Viewing all customer Discussions for:

Door & Window

Len

Hi, I need three sets of balances as pictured above. Six pieces total.Width of the balance is 1/2 inch.Length is 25 inches, not including plastic ends.Writing on the side, as shown in the photo, reads: 24-3 GK5 CMC 43Thank you so much!Chris

I am in need of a 3230 Block and Tackle Balance with a 18-030 Shoe and a 19-015 Top. Do you sell this as a complete set-up?

Marking: 08 3 BSI DR Window brand unknown, maybe Marvin. Vinyl

We are looking for a sliding glass door handle and lock assembly...

My locking mechanism fell inside the door when I was replacing the handle. I cannot seem to be able to locate the correct replacement lock. We recently purchased a locking mechanism from your website part #82-218 but it didn't fit. I have a few dimensions it's 1/2 inch side to side and 3 11/16 from ... (cont.)

As you can see from the pictures, the string broke on one of my window balancers. Can you sell me the replacement part? Is this enough information or can you help me determine how to give you more information?

I need to replace 2 balances with the # 3458 stamped

the ones we have were advertised as three-quarter by quarter and have a leg

I need help identifying the Series for my 2930 Channel Balance for a Non-Tilt Lawson Window. Photos attached. Thanks

How to remove and install Glazing Bead 65-159

This is a two panel slider, one panel stationary. The felt weather stripping at slider/stationary connection is shot - house built in 2000. Took both panels off, can see weather strip on stationary panel (see photo) but it will not move/slide out. Do I have remove door top piece to replace this stri ... (cont.)

I'm attempting to replace the switch on this lock. Patent 5125703 off white. Please help. Ron

Looking for something as close to the attached image as possible, for replace T slot seals on operable vinyl exterior windows.

Nami replacement handle with lock MST 51168 I need the replacement handle with the lock because the lock is broken. Having a hard time finding one. Would sure appreciate any help! Thank you!!Debbie

I HAVE 4 OLD ALUMINUM WINDOWS NON OF WHICH HAVE CHANNEL BALANCES THAT WORK. IN EACH CASE THE SASH MUST BE PROPPED UP TO OPEN THE WINDOW.NONE OF THE CHANNEL BALANCES ARE INSTALLED. I HAVE TWO OF THEM THAT ARE RUSTY AND LONG AGO REMOVED AS EXAMPLES OF WHAT IS REQUIRED.BSI 22101/2" ALUM CHANNEL IS 23" ... (cont.)

Need to purchase

Hi, For a 1956 cabin in the desert by Joshua Tree we are looking for 2 levers like the one in the picture, with the exception that the 2 units we are looking for is for a left and a right window. This requires there to be one locking mechanism only. (The one in the picture has a locking mechanism sh ... (cont.)

Hi, The cabin was built in 1956, we are looking for 2 left and 2 right window handles that will fit the same specs. Preferrably in aluminum or white, but we can paint, if no other colors are available. Thank you for your help! Hans

Can I add in the lock by replacing your handle - will it fit this glass door I have?Thank you