Viewing all customer Discussions for:

Door & Window

I purchased 15-045 before removing these. That one is not thick enough and the pivot hole is too small.

There is a raised symbol of Texas with MDO on it on the back of the latch. Thanks!

This is a metal bifold door, its 30" wide. Hoping to find the pictured track for a couple of extra doors I need to installed. Thank you.

I believe I have Atrium Double Hung windows installed in 1995. I am looking for the vent covers located at the bottom of the window frame on the outside. The opening for the covers are 1/4"h x 1"l.

Double Pane window. Vent stopper. I will need 5 of them.

Crank on right side of window. Lock on left side. Outswing to the exterior right.

Looking for a new handle for storm door

Please find a replacement for this part. See measure in photo. Thank you! Debbie

I have two questions. I am looking at 82-002 to replace the broken lock on the patio door, but there are some differences. 1) Do you think it will fit? The measurements are perfect. 2) As you can see from the picture, the door handle/pull fits under the screws. Will I be able to attach the current ... (cont.)

Please tell me if you have these. Or an after market. THE LENTH IS 12.25 4 TOPPS AND 4 BOTTOMS NEEDED.

we are trying to find the correct balances. The stamp says C4950 and I have attached a photo of the shoe we are needing as well.

I have some channel balances that have broken tension cords. I need help identifying the bottom piece of the balance. It is a single plastic piece which fits into the bottom of the channel and has both a set of pulleys and a track slider. Can you identify it, and do you sell replacement parts of ch ... (cont.)

I purchased this home a couple of months ago and all 4 closet doors have broken wheels. I know that the home was built in 1977 so no big box stores have these. Also tried hardware stores and they don't have them either. Hoping you do. Thank you!

60-4540 window balance x 46" long. I need help identifying the top and bottom balance brackets and top sash guide. Thanks,

Hello, Your 15-015 has the right outside dimensions, but I'm not sure about the size of the pivot bar pocket. My pivot bar has a stamped U shape, 0.315 wide by 0.190 high. The pocket in the shoe is about .33x.22. Will the 15-015 accept the pivot bar I have? Also, my spring balances are unlike anyt ... (cont.)

Please see the attached pictures of sliding door guide assemblies to recommend a match for the replacement parts.Length of assembly is 4 1/8".Height is 1" Width is 3/4" I believe the wheels are 1 1/4" diameter. Not 100% certain. Thank you.Mike S.

Looking for a replacement for my handle-less window operator. The casing looks different from the one on your website, I'm hoping to not have to redo the trim around the window to accomdate a different type of opener.Thanks!

Hi, I have what appears to be a 14? series 380 based on the channel dimensions of 9/16? and the shoe dimensions of 1? x 15/16?. My sash weight is 14 pounds. The only other marketing as 135GR Caldwell. I am looking for the appropriate selection for my sash weight. Thanks Adam

My windows are so difficult to raise and make a loud clicking noise. My house is 15 years old and I was told that I need to replace the balances in the windows. I have taken pictures of the hardware which I hope will be helpful in helping me to identify the parts I need. They are 32" long. ... (cont.)