Viewing all customer Discussions for:

Door & Window

I am looking for this window part in both a right and left hand. I believe the windows are Alpine

This is a picture of my left hand crank that needs to be replaced. The control arm pictured goes to the bottom window. The upper window control arms connect through threaded plastic hook pieces. I need to replace both styles. My rivets appear to be larger than in your photos. I need your expert advi ... (cont.)

It?s rusted out. Need new bottom track and hard ware for the bottom.. these are metal glass bi folding doors.

You guys have been lifesavers. We have a 33 year-old house with 28 tilt-out spiral balance windows. Paying somebody to come out and repair them was breaking the bank. I have used up most of the parts I ordered from you before. I need to reorder them, but am hoping you can supply this piece. While I ... (cont.)

Do you think that 26-125 is a good replacement for this pivot bar ?

Hi, I need help on this...don't find it in your website.

I in need of these parts and instructions in replacing them im looking for the bottom hinge and the top two wheel hinge. I believe these were made by renin.corp many years ago.I took multiple pictures. Cary

I need a return spring for my windows it is plastic and keeps breaking windows purchased in 2007.

length 2 5/8" width 5/8" thickness 3/8"

My pivot bar matches the dimensions for part 26-021. The thickness of mine is 3/16". Is this the same dimension for the 26-021? The only marking on the pivot pin is number 2311. The T-Lock balance shoe looks like your part # 15-194. All the dimensions given match my unit. The window balances a ... (cont.)

Trying to change to a outside KEYED Lock please advise which items I will need to purchase to complete the conversion. Thanks

I need a left and right side window lock guide. It says Stipulates Conformance is the manufacturer. Vinyl Window. Has two screw hole on top.screw holes from center to center are close to 2 1/2 inches.

What is this piece called and can it be replaced? Windows are single hung.

Would like to replace. There is a kerf that weatherstripping fit in

Hello, I am desparately trying to locate more of these window locks. I have about 20 windows and only 10 or so of pieces that go on top of the square metal piece. I have included two photos of the actual levers (one on its side and the other upside down so you can see the square insert). I cannot ... (cont.)

70-191 IN SANDSTONE?

Hello, I needed to order a pair of channel balances; the markings on the existing reads 33F BSI EC. From what I can tell, I need to order the S795-33 modified with clip attachment 15-198. I weighed the sash and it is 34 pounds. Can you quote me on the cost to order a pair of these? Thanks, Justi ... (cont.)

Hi I just received the four 30" series 600 balances from Swisco. The outside of each tube had a thin layer of "grease" coating the surface. Is it supposed to stay there or can I remove this "grease film" before I install them?Do the spiral balances come "charged with tension" from Swisco?There are ... (cont.)

My existing milgard patio sliding door has a tumb lock from inside and I like to add a key lock from outside

This is the end view of my GRAY T spline rubber gasket that is on the edge of each door where they touch or connect together when the two sliding glass doors are closed. I don't see any similar product here. The bottom that goes into the T Channel is ¼" wide. The fin going up is about 5/32" high. Ca ... (cont.)