Viewing all customer Discussions for:

Door & Window

70-191 IN SANDSTONE?

Hello, I needed to order a pair of channel balances; the markings on the existing reads 33F BSI EC. From what I can tell, I need to order the S795-33 modified with clip attachment 15-198. I weighed the sash and it is 34 pounds. Can you quote me on the cost to order a pair of these? Thanks, Justi ... (cont.)

Hi I just received the four 30" series 600 balances from Swisco. The outside of each tube had a thin layer of "grease" coating the surface. Is it supposed to stay there or can I remove this "grease film" before I install them?Do the spiral balances come "charged with tension" from Swisco?There are ... (cont.)

My existing milgard patio sliding door has a tumb lock from inside and I like to add a key lock from outside

This is the end view of my GRAY T spline rubber gasket that is on the edge of each door where they touch or connect together when the two sliding glass doors are closed. I don't see any similar product here. The bottom that goes into the T Channel is ¼" wide. The fin going up is about 5/32" high. Ca ... (cont.)

The plastic gliders on our sliding mirrors doors are broken and we cannot find similar replacement parts. See photo

I purchased a tilt latch actuator #26-234. This appears to be the correct one but when I try to put it in the actuator spot it sits up about an 8th of an inch. Is there a trick to installing these.

I have a fairly broken 29" SERIES 795 CHANNEL BALANCE (I'm guessing). I have never done any window repair so I'm sending pics, just in case. I can't find any manufacturer on my windows. I think they are Andersen series 200double-hungs. There is a small clip at the top which I have included in the ... (cont.)

I am looking for 3/8" tall wool pile weather strip by 1/4" wide, for replacement windows.

I have a 25 years farley windows. I do need bubble weather strip. Do you sell those weather strip? If not, can you tell me where I can by? I live near Ottawa

How long is the rod on AWNING OPERATOR KIT, SHORT ARM Product Code: 39-390? Thanks

Does this latch work with current spindle?

My granddaughter recently purchased a house and we determined there were issues with some of the windows. They are double hung tilt windows. We were fortunate enough that there was some documentation left at the house that showed the purchase of the 25" series 600 spiral balance (S600-25) from you ... (cont.)

QUESTION: DOES THE 39-032 HAVE AN 8" )APapprox) aarm as does the crank in my picture? I want to be sure to order the right part.

My granddaughter recently purchased a house and we determined there were issues with some of the windows. They are double hung tilt windows. We were fortunate enough that there was some documentation left at the house that showed the purchase of the 25" series 600 spiral balance (S600-25) from you ... (cont.)

My granddaughter recently purchased a house and we determined there were issues with some of the windows. They are double hung tilt windows. We were fortunate enough that there was some documentation left at the house that showed the purchase of the 25" series 600 spiral balance (S600-25) from you ... (cont.)

I am looking for these operators, I know that its made by Truth and the patent # on it is 3064966.

Looking for this part, it's a window balancer spring and terminal housing. As you see, the housing is broken

Broken right latch

balancer marking 26C need replacement end shoe