Viewing all customer Discussions for:

Door & Window

I have 3 pictures of the balance that I need to replace. Part 27 C from United Windows. Please let me know if you have such a balance and the need information to order from you. Thank you,

30 year old aluminum windows. No brand marking. Need to replace a lot of the snap-in vinyl glazing. Do you have any product that would fit? HELP

Anderson Mortise lock for storm door

Would I order a s140 13?

Hello- I had a balance go bad on me this weekend (Made of fun times trying to catch a window while it's falling out). I've provided a few photos of the balance, I am looking to replace. Can you tell me if you have a replacement balance like the one attached? I took a couple pictures of the length ... (cont.)

The handle for outside of door is broken. I want to replace both inside and outside lhandle .

I have the Narroline double hung windows from the late 1970"s. Need to replace sash balances on two windows identical in size. The visible glass is 36 3/8" wide by 15 9/16" high for both top and bottom. What sash balance should we need to replace it.

Looking For Replacement Rollers

Gentlemen, I purchased several of your 81-005 roller assemblies for my SGDs, replacing the original rollers in my Acorn 400 doors which were installed in 1984. The rollers fit nicely. My concern is how long I can expect them to last in our salty environment. The home is located directly on the Gulf ... (cont.)

Hello, through research on your website and question and answer section I have determined that I have ply gem windows and suffer from the all too common window balance and balance shoe issues. I have also determined the replacement parts that I need to get my windows being windows again. I spoke wit ... (cont.)

I am trying to change the glazing in the windows of a house i bought.

Do you have anything that would work to replace this storm door latch?

It is a door lock for my screen door on the outside has a straight handle on the inside that's a little straight handle with a lock above it.

Sorry, but I don't have any numbers nor photos of the uninstalled unit. I can obtain them if needed. It is at my BIL's house 90 minutes away. The unit functions fine, except when trying to lock it using the key.

stamp says 1540 B.S.I. PJ For a 20" x 20" window approximately 12lbs Would like to replace, need to know what to order. thank you

These windows previously had pins on springs, which were pulled back to allow movement of the lower sash. They fit into holes in the track, but this only allowed lifting to pre-specified heights. As well the windows stick, so that manipulating the pin and lifting the sash at the same time was extr ... (cont.)

The crank on my window is stripped and I can't get it closed all the way. I live in PA and this is for a condo in Florida. Stupidly, I did not measure the device or bring it back with me, so I can only guess about the measurements. I'm going down there in a week and would like to take something wit ... (cont.)

Please let me know what replacement parts would I need for the housing and pivot bar. Need housing and pivot bar. Thanks for your help.

Need this hinge.

I have these crank handle windows where the crank mechanism is broken as the collar for the crank (pic 8) does not hold in position as the thread looks damaged. So, when you crank the handle it juts pulls out the rotating threaded shaft. Is it possible to repair or replace the whole mechanism? I h ... (cont.)