Viewing all customer Discussions for:

Door & Window

Trying to figure what glazing would be compatible

I removed both spiral balances and with both I can easily wind them up by hand, so I guess both are shot? Cannot really see a tip color, but possibly are black. Length is 28" and diameter is 3/8". Window sash weight is 16lbs. The bottom of the spiral balance connects into rectangular plastic/nylo ... (cont.)

Hi I have some bad balances on 5 Bonneville DH window units. They are 30410 (sash opening) Can you supply me with (5) sets?

Looking for the plastic retaining brackets for simonton casement windows

I need to replace this lock, it does not have any markings or name or numbers on the lock or handle or door. it is a sliding patio door in a condo built 20 years ago. the part on the door is 6" long and 3/4" wide, the other part is 4 1/8" long, 10/8" wide and 1/2" deep. can you match it? ... (cont.)

My Simonton windows manufactured around 2000 appear to take the Maxim Dual ARM Operator, Sill Mount. The current operator has the word "truth" engraved on it and the number 31858 on the window with the lock and the crank on the right side(when viewed from inside). The 2 measurements are 4 7/8" and ... (cont.)

The white ones pictured are replacements and seem somewhat new-ish. Though I'm looking for Black Nylon if Ic an find them for a reasonable price point. Top hole looks to be 3/16 on center from the top. Bottom hole looks to be about 1

This is a 30 inch channel but I cannot find anyone that looks like it on your site.

Cannot find any identifying information on this very old 5 ft. slider door, but here are pictures

I

Hello, I

Hi I have a few glass doors inside that use this system. I tried to clean wheels on one set because they stopped rolling. Would prefer just to replace. The tandem wheels unit is 41/4 inch and 11/4 inch depth. The wheel is about 1/4 inch wide My wheels have all jammed up and will not turn. I tried ... (cont.)

no names only those number on crank assembly

There a marking on back side of knob part that says(104L) Can or d o you have anything that may be close needs to fit a 1

What is a good indicator that I need to replace the rollers on a series 400 fw patio door? installed approx 2008. door seems to slide OK, not great but really don't remember what great is, but seems worse the colder it gets. Thanks

I need to get at least a couple of these awning operators. But I do not know how to Identify the maker. I have attached several pictures with measurements in the pictures. It is a right-hand operator shown in the pictures.

I ordered a new operator for my window. How do the retaining screws come out without destroying the bottom of the window seal?

I have som 1998 Pella Proline casements. Unfortunately, when they were installed, my builder scraped off all of the serial number decals. How is the rainstrip installed? My experience would be to use a screwdriver to push it into the existing channel. Something tells me I should stick to my day jo ... (cont.)

I need new wheels for my 5 foot slider. It is approximately 20 years old.I am in cleveland, ohio but door is in condo unit at Hidden Valley Resort in Pa.

I need to replace a patio door inside pull. Stamped as DNS Industries 16 inside pull standard. Patio door locks and unlocks from inside only. Measurements match your 82-008. 7-3/8 X 15/16. Screw centers 6-5/8. But Your latch is facing down and my latch is facing up. Thanks Lydia