Viewing all customer Discussions for:

Door & Window

We are looking to replace this hardware

The channel balance arms that I have is 12 and a half inches long and the number on it is 12205 can you help me find this part, thank you

Hi, I am trying to find the part in the picture. Which is the bottom part of the up and down sliding window that clicks into the sides/sash. I went to a lot of places, but you might have the pieces. Your helps is much appreciated. :) Thank you so much.

I have a customer in need of four of these. Can these be identified by this picture? Thanks,Jim

I need 4 sash brackets.They measure 2 7/8 wide by 11/16.i also need 4 awning tracks. They measure 11 3/8 by 11/16.These are for marvin casements and are about 20 years old. Thank you.

What lock is associated for a face mounted keeper 90-169?

Nami NFRC

Installed in 1984. The latch parts on the left and right doors were removed in order to install a dog door panel. Then they were lost.

my block and tackle balance is 37" and stamped 3650 with BSI rotated 90 and TL on it.I want to replace the balances on on the one window that has both tops broken off How can I remove the window to remove the balances when the top clips are missing and wont retain the balance?

I'm looking for a replacement for a Truth 40055 operator. It is 13.5 inches from pivot point to nylon wheel. I can't find the exact part can you suggest an alternative?

Do you have complete window chanel balace, where metal part is 29"long? Depth 16 mm, width 14mm.

Hello! I need a mortise latch as a replacement for a sliding door handle with a Canada patent number: 3596945. Is 82-211 the correct part?

The balance is stamped 28D need to replace

These are rollers for the sliding door on my boat. They don't have any part numbers. The wheel could be 1 1/2" possibly, but 1 1/4" is best.

Please help on checking out specifications on vinyl beading on pictures attached

Hello I have some Nuprime Windows that need replacement channel balance. I think I should order 390-22. However the old balance measures 21 5/8 inches measured the way shown on your website. My balance has 2130 stamped on it. What is your opinion? Thanks Ps I put balance on table and measured ... (cont.)

Screen mounts on outside of vertical slider window. Some screens are missing this clip spring and therefor do not stay in position. I do not know the name or brand of the windows, but they were originally installed in a new home in 1998 in Henderson, NV.

I have single hung Simonton window left side double coil balancer broke. My question is one of the coils have a #3 stamped/ engraved in it , but the other coil stamp isnt visiblie. I recently ordered series 160 coils 3.5 & 5.5 lbs for replacement. Did I do the right thing? I was thinking the 5.5 go ... (cont.)

I'm looking to replace all the components (coil balance, pivot shoe, support cap, flange, and barrel) for my Weathercraft vinyl window (44" width, 22" height, 28Lbs). Please provide guidance on the following: 1.) Part numbers to completely replace the coil and related components. 2.) Coil weight ... (cont.)

I am looking for right and left hand cam pivot for old barricade windows. I cannot see any marking e.g., part numbers on the pictures I have sent you. Hopefully with the dimensions you can suggest an alternative. Thanks