Viewing all customer Discussions for:

Door & Window

Wedge that fits into sill channel to retain screen frame

I have all the windows with the attached balancers marked 26 9 HR CALDWELL. The metal to metal height is 27 inches and the bottom width on the plastic is 1 inch per picture. can you tell me which balancer should I order from you? thank you

We're looking for replacements and the installation of the mechanisms.

Need an identical replacement part.

I need right and left Window latch L-307 I think other side is 305 not sure L means left. Sizde of latxches you have are not as long , would like to match existing screw holes. Would appreciate any possibilities

can you tell me if the crank handle 39-205 has a set screw? I can't tell from the photos. Thank you!

I need to know the correct roller bearings to purchase.

I just recently bought a house and the windows are uniframe. The tilt latches are broke on a few of them which has resulted in the glass getting broken from them falling out of the frame. I'm having a hard time finding the proper replacement parts if someone could point me in the right direction pl ... (cont.)

Hi, the window crank comes right off in my hand when I try to use it. I'd like to replace it

Have 2 windows. 1 works ( took photos from that one ). Other windows doesn't open at all. Bought new crank but doesn't open. Would appreciate some help.

I am needing to repair a bunch of windows that do not stay up. This is the part that slides into the side of the window frame. There is one on each side. The pin piece is Alison broken.

I need a new one, this one's broken.If not available, please suggest a system to match your analog (product code 26-129).Window sash length is 32''.

Hi I'm looking for some window tilt latches to replace these (I need several for right and left sides). They are in "Ideal ultra-weld" vinyl windows and the back of it says "PAT. #5,139,291" and "8K" and "75". I'm attaching pictures of one, but note that the little triangular plastic piece that hold ... (cont.)

hello, I am looking for assistance in identifying this window tilt latch so I can go about finding a replacement part. There is pat. # 5,139,291 on the bottom

Pivot bat is 3 inches long and has 2 holes. Pivot bar shoe has patent 4.610.108 stamped inside

Mounting holes measure 3-15/16" but as you can see the lever that acuates the double mortise latch is not centered. It is more toward the bottom. Center of latch measures approximately 1-1/8" from bottom mounting hole. Thank you for any help on this matter!

Classic double hung non tilt windows. Left side sash cord broke. Only numbers on the sash are 22r. Can't seem to find a match. Windows are solid wood with igcc glass.

Balancer for window

Need two or something that can still slide, lock into side slot. This one is bent. Other broke off

Hello, I have 2 windows that need the each need the left and right balances replaced. Can you help direct me to the appropriate part?