Viewing all customer Discussions for:

Door & Window

Could you please help me identify the following part number I need to order left and right side for window 32x25-1/2 not sure what lbs it would be

18-3 IE5 CMC 45 overall length is 19.25 and that is the metal only. Total length is 20 and 1/8. I have no other information than it is a pass through window at a snack bar.

Windows will not close shut or turnout complete because of cranking system. Please help

I'm looking for the tilt latches. All of the windows were checked throughout the house. There is no manufacturer identification whatsoever.

Sliding screen door rollers replacements (4) prefer metal rollers if possible.

would like to replace this (would order several). please let me know what you think. screw holes are 1.75" c- c overall length is 2 5/8 in 3/4 in wide, 5/16 in thick. thanks for your help

Stamp 19 3

Hello, I ordered 2: 30" Series 378 Channel Balance S378-30 Option: 2950 I installed the parts, but my sash isn't catching the channel balance. I removed the window again and saw there was a plastic piece on the side of the sash that was half broken off. I'm not sure what this part is called, but ... (cont.)

Need 2 of these balances stamped 14-6. Note the blue spacer in the underbelly.

Hi,Would you please send me a new balance for my window (see pictures)? It is a double-hung window and the channel is 32 inches long. Please let me know if you have any questions. Thanks,Robert

I have several DH tilt windows that need the spring and pivot shoe replaced. I've attached photos of the pivot shoe and spring (16" long). From what I understand, the brand is Unique Window Systems out of Canada. Please let me know if you have these parts available, or where I might find them? The p ... (cont.)

I just want to make sure as best I can to get, the right part

Do you have a replacement parts?

Unfortunately, I do not have any markings on the balance that is already installed nor on the one that broke. Please let me know what else I can do to help with identifying the balance I need to help the bedroom window stay open. Thank you for the help!

The rail that makes the window go up & down, & the part that makes it stay open fell out. We need the parts for both sides of the window.

Two casement windows need Arms and Crank Assembly. One left and one right.

Hi, I am looking for this hardware for one of our residence life buildings. I have attached some pictures for reference. Is this something that you have in stock or can locate for me? Please let me know if you have any questions. Thank you.

Markings are Allen Stevens Corp. Woodside NY. With numbers 83 and 14 underneath the 83

Need non tilt Balances for Pella window. need to verfiy which one.1/2 inch Channel, metal end to end 26 5/8 inch. Clip photos attached with measurements.Thinking its the 385 - 27 inch with 2630 weight. Photos submittedThanks,Brad

Hello, I am looking for this operator for a small casement window. Its a truth brand and the arm is 8.5 center of gear to center of nylon glide. Thanks