Viewing all customer Discussions for:

Door & Window

I am trying to identify and purchase four sash glide/guide clips for a Milgard aluminum frame window circa around 1988.I have a photo if this would be helpful.

1960's latch is broken on our DorWal slider door (images show broken latch separate from door; door handle still shifts perfectly up and down using turn knob). Is there a replacement latch available or alternatively is it possible to replace the entire handle set but still use the existing sliding g ... (cont.)

I need two window balance replacements. They measure 1/2" x 26" channel.

Looking for replacement. Here are the identifying marks I found: D92 7 #27 7 79 And on the other side: 600-2 Measurements: 2 15/16 by 6 1/4 (not including tab on end)

i am looking for replacements for 22 inch 5/8 tilt window spiral balancers for tilt window green tip

I need two replacement block and tackle balances. see attached pictures. 21" length metal to metal. 5/8" depth. I think the stamp is 2040 on the side. any advice of how to order?

The top guide of the channel balances I need to remove have small "wings" on them such as the 19-004 top. These "wings" ride inside of slots and prevent me from pulling out on the top of the balance to remove it as shown in your video. What is the proper method for removal in this case? I do not wan ... (cont.)

I am replacing the insulated glass and there are several 44" horizontal glazing trim missing. The bigger sides are 3/8 and the smaller sides are 1/4. I have never seen this odd shape glazing....but easy to remove. I have it stuck thru a piece of white paper for contrast

measures 27" long and about 5/8" wide. Picture included. Marking on the side read: 26-4 AA CMC 7 Please advise which parts I should order. Thanks! James

I am replacing side channels. I need 28 inch metal size + shoe and top. What stamp should I buy? I have a Kauf man and Broad installed installed windows. The stamp on it shows "27 4 HP Caldwell" Please let me know. Thanks, -Raj

The screen clips come in plastic or metal and are just under 2" long

Our Owens Corning Windows were installed in 2000. We need to replace the Sash Support Balance Coils and Hardware. Can you help us identify / locate these parts?

I don't know the manufacturer of my windows. I'm looking for the replacement pivot shoe (image 1 & 2). This shoe hooks to the balance on the bar below the spring (image 3. Do you carry this pivot shoe?

My window crank just spins now with no friction or window movement. Looking to replace the mechanism.

Can you tell me how thick the clip is? Or, if I use this clip with a #8 pan head screw, what length screw will I need in order that, once inserted in the clip, 1/2" will be protruding out the back?

I need the following keeper for my latch. This is an older wooden Pella door, made previous to the year 2002. The length of the keeper is 3". See attached pictures. Thanks for your assistance!

Good evening I am looking for replacement locks. The lubrication did not work. The ones pictured below appear to be like your but the center latch goes down and not up. Any advice?

We have had our doors many years (Sugar Creek brand, I believe) and we want to replace the handles due a marred finish. In considering the 40-058 sets, does the "polished brass" hold up as well as the "antique brass" finish? Do both have some sort of protective coating, and if so, how long does it ... (cont.)

I NEED A REPLACEMENT SASH FOR D86 7#27 2-79 1600-2. CAN U HELP? DAVE

Does the 18-127 top sash guide work with the Series 380 Channel balance with the 19-005 top? I do not have an original part to compare. Thank you.