Viewing all customer Discussions for:

Door & Window

ARM stamp is 55003. Andersen Windowalls stamped on arm also. Thanks.

Hi, Thanks for your advice on the top sash guide. I have another request in which am Not sure which part I should purchase this is a half inch snap in glazing in which appears to be bent. I'm not sure of the original appearance since it has been on the window sash since 1982.

I have been trying to replace metal spline on Anderson screens but struggling. I think .250 is right (i have .230 just a bit too small). I don't want to end up with another pile of spline that wont work. Do you know if .250 or .270 is a better choice?

It has WRIGHT on the operator itself, I have attached a picture of the operator itself and a drawing with the correct dimensions. Do you have these? They are Gold colored. hurd

Looking for something that will operate these old (1950's) awning windows. Hinges are exterior and there is no internal hardware, only what you see. I bought a couple of 39-268 hoping they will work. What do you think?

The crank is stripped out can you help me. Thanks Clay

Hi there, I have a very large home with Semco windows throughout and I am in need of two replacement cranks. I have included photos of the crank, the two I need are identical (left sided) and are stamped with a #19, made in USA. The crank measures approximately 5" in width, the window is approxima ... (cont.)

The lock broke off when I tried to turn it to open the lock. The picture is included Would you please let me know if the one on your web site will fit. It looks to be the same but I'm not sure.

I found your website and it looks like your part 39-399 is the replacement for the Roto OP05-7532-03. Would you please confirm that this is a compatible replacement?

The number stamped on the channel is 2630. 1/2" wide 27"long. I need 4.

I have a Simonton Vinyl window that has a broken coil and pivot bar. It looks like the 15-205 is the right fit, but not sure how to remove the current one and how many coils are in the window coil balance I need to order. I can see the screw and then some latches that appear to lock the cover in ... (cont.)

I have a vinyl window (unknown manufacturer) and the channel balances have failed. I need a replacement part. Can anyone recommend a replacement part? Thanks,

I have two windows with 29" long 2840 balance pairs broken and one with 29" long 2830 balance pairs broken. Please tell me what replacement complete balances to order. Two images attached for ID purposes. Thanks in advance.

I have a broken spring balance for my PGT window. I have managed to extract the broken balance and taken some photos. Based on your web site I think it matches your Series 395. The top appears to be the same as your 19-005. The shoe appears to be the same as your 15-001. The length of the metal ... (cont.)

The roller is 1

Will your sash clip 17-005 replace mine.

It seems like the balance top guide broke and popped out and balance rides up the channel. When I push down on balance, I feel spring tension, so I probably need a new unit. Unit is marked 3650, but cannot find a photo on your web site. Is this unit available. Thanks Frank H

Thanks for your help

Dear Swisco, Hi, I

We have several Viking Single hung alum windows that need balance tubes and finish corner caps seen in the attached photo (Black). We can measure the balance tubes but need help identifying the black corner piece. thanks