Viewing all customer Discussions for:

Door & Window

need 50 of left - 33023-lh , and 50 of 33024-rh

Will 39-357 fit the Milgard Tuscany casement window. I'd like to extend the crank 6-10 inches. Will I be able to attach two 39-357 extensions together along with 39-121 Crank Handle?

hi i need 2 of those things in the channel that are held in with 1 screw for the lower sash to stay up. i did not see anything on the website. i have no mfr info. it is in a town house in PA about 10 years old. dimension approx 1"x3.5"x1/2" thick. tim drewes t l drewes home improvement ... (cont.)

I am looking for the security clips to replace on my windows. SWISCO Double Hung

Hello, I have a 23.5x35 inch (roughly) kitchen casement window (Andersen), and the crank handle no longer closes the window. It will open, but the crank simply comes out of the fixture when I try to close the window again. Reading other posts, it seems like the worm screw has disengaged. I have att ... (cont.)

I have Series 9555 Capitol double-hung tiltable windows and have had a few cracked coil balance shoes when doing Spring cleaning. I am not certain what exact replacement part I need and am hoping you can let me know based on the photos I have attached. If you require further information like measure ... (cont.)

I have a 1986 36" Stanley steel entry door. The cat clawed up the lockside weatherstripping. Bad kitty. Is the 58-008 seal kit the correct replacement weatherstripping for this old of Stanley door?

Hi Mike, Our windows have plastic strips around them that have weathered a lot and need replacing. We have a lot of windows, and they all look bad because of these plastic strips. They are similar in nature to your vinyl glazing bead strips, but they do not snap into the window. The u-shaped ... (cont.)

Latch is on the left hand side of window, hinges on the right.

I need to replace the window bead on my aluminum windows that were damaged by hail. I bought these windows around 1995-1997 from Lowe's, I think.

Unfortunately i don't see any names, numbers, or markings on these. There is also a plastic piece that come down from the screw that has broken off.

is there anything I can do to maintain my windows to prevent the window from sliding unequally on each side and jamming in the sash?

The crank handle mount completely broke and the handle has come out. The windows are rather old (CertainTeed). The long arm appears to be 9". The assembly is TRUTH and shows number 40471 stamped on the base. The short articulated arm shows 20810 on the end by the window attachment and 30841L on ... (cont.)

I have 16 double hung windows I would like to replace the left and right spring loaded latch. Can you please tell me what replacement part number is needed and what is the cost? I have attached the 3 photos to aid in the identification. The photos are the top, bottom and side with a ruler to aide i ... (cont.)

Hi, I have two windows that both need a pair of new window tilt latches. I believe these are older Harvey windows, but am not positive. They appear to be the same style latches that I have on my new Harvey windows. They are 2 5/8" long (with the tongue of latch broken off), and 11/16" wide. ... (cont.)

Hi, I recently bought one 39-005 jalousie crank handle to see if it would fit my old jalousies. The shorter bar (that connects to the gear inside the handle) is 2 1/2" long. My old one has all of the same dimensions, EXCEPT for the length of this bar. Mine are 3 1/2" long. Would you happen to have a ... (cont.)

Hello I'm looking for a pair of window balances for a double hung from Kolbe Kolbe. They are tilt in windows. The balances are beige in color and have 28-HD stamped on them. There looks to be a small black and silver piece which I think might be the brake?

Upon research it may be called a "vent latch", but unsure if this is the name. I have old aluminum awning window and as you crank it opens, and shuts but you can still push the window and it opens a little. Upon taking a picture it appears that the side that doesn't latch to be closed is broken. T ... (cont.)

I we have Anderson windows A/W 87/1 was installed in 1988. window size each sash 36" wide and 26" height total 36X52 or 36X53 both top and bottom sash. what number balance I need? total 4 windows balance string is broken.

Window could be an alenco or atrium. No information on windows of glaze. the glaze is almond or beige, light colored tan. measures 11/16 x 11/16 First pic shows the snap in. Second pic to show coloring. Do you have any that look like this? Thanks Joe