Viewing all customer Discussions for:

Door & Window

I have wooden casement style windows with what I think are called Operator Dual Arm controls. The handle says NORCO. In researching the web it seems they may be Jeld Wen windows. Do you sell replacement parts? I didn

I need to replace a missing plunger pin on a screen. The screens were installed with Marvin windows in 1997, no other identifying information. I am sending photos of the existing pin on same screen w/ a measuring tape to show size. (FYI - the tape measure is laid across the top of the screen frame ... (cont.)

I want to order ten (10) of this balance. Please, help to identify the balance and send me quotation.

I need a set of counter balances, but not sure about the number. I have an Andersen double hung window. I believe it is a 200 series Norroline 3056 C (Cottage). The number on the counter balance bottom right corner, is D2010 3177. I'm guessing it's a 1031 because those numbers are large. The ... (cont.)

I am trying to identify a plunger pin for a full screen window. I believe the 5/32 is the correct one. It is for a Weather Shield window screen. Is there any other measurement I would need to take?

Hi, I have Alenco windows from 1987 and need to find replacement glazing snap ins. The profile looks like the 55-161 except the top width is 1/4". The height is around 3/4". Can you help please?

measurements are the same as 26-040 ,difference is 2 screw holes ,located 1 inch back from each end,one hole each end. also are these made of ss?

Can I cut the 6ft 80-110 to fit my door an will I need two for a sliding screen door?

part is at the bottom of the glass panel that opens on a truth casement window< it looks like a guide of some sort

I need about 30 latches if its possible. Thanks!

Hello Customer support, on your website I saw a similar coil to mine shown in the photo. It looks like the 190 series. We have 2 coils as shown in the pic, one is stamped 740 the other 840. Your site has the 740 but not the 840. How can we find the 840? Is there a special tool to replace these coils ... (cont.)

Identifying marks on roller: del mar eng Long Beach, CA Pat. # 3.670.357 Dimensions: 2-1/2" long x 2" tall x 3/4" wide roller is stamped "Kilian" Syracuse Toronto attachment piece is verticle w a 3/16" hole

My numbers don't match anything on your site. 1160-17 E75 9#27 11 83 as best as I can determine as the stamping is very difficult to make out.

On your web site I found 85-864 But It is a little different size What do you think? Russ

Could you please give the rest of the dimensions for the other sections of the clip?

I would like replace the rollers and door handle/lock.Do you carry parts for the above mentioned model. Thank you, Howard

Dear sir, I have 1/2" x 33" balance but not sure which ends? Can you help? Thank you, Randy

need to determine which balance to order as a replacement for this andersen window balance.

Replacement parts I'd and pricing 1) mostly need the corner with pins. Mine were nylon, rather have metal I think 2.non pin corners 3.) latches 4.) latch springs 5.) On the window side of the frame each channel as plastic rub strips installed in a narrow slot. I would like the strips or subst ... (cont.)

I need to replace rollers on my mirrored closet doors which are pretty old. The product, Mirrored Closet Door Roller, Round Product Code: 23-042, seems to be the closest to it. The dimensions are the same except in length. The one pictured online is 3" and mine is 3.5" but because the screw goes thr ... (cont.)