Viewing all customer Discussions for:

Drawer & Cabinet

Hi, I would like to replace my existing kitchen cabient door hinfges with soft close. See attached photos. On back of hinge; 84.555 .01A Blum Thank you

I want to buy a Rear Drawer Guide for my furniture (broken), and I want to know if is good or not. I saw your rear drawer guide and I think is the same. Your product code : 32-036 On my rear drawer guide is write : RANTHOR (P)REISS CORP. N.Y.C R-40-28 PAT. N°. 3,201,187 My ... (cont.)

I am looking for the pull handle for a Standard Furniture dresser drawer. I have looked every where. Your help would be greatly appreciated Thank you, Michael H.

Purchased in 2003 on the back 03087 87 is tamped on the back.

Hello-I am looking for replacement hinges for Homecrest cabinets that no longer stay closed. Pictures attached and I believe part number is 0308736

Plastic rail connector broke. Need replacement.

New construction i 2013. The cabinets are Armstrong, and the plastic socket does not use screws because it attaches to thin wood on an island. The part says c-367 on it, and it also says made in USA, and has a little picture of Texas and Tennessee on it.I can't seem to find one anywhere, and one of ... (cont.)

See photos of hinge. The portion that screws in to the cabinet (with one screw) is 2 3/4 inches high and the portion that screws (with 2 screws) into the cabinet door is 1 1/2 inch high.

Hi Fould you on the web. Can you help me with this one?! Need of one or two pcs. Brand: Mepla (or similar) (did I manage to add 3 pics?) Best regards Fredrik

Installed in 2007 Standard Pacific homes in AZ.

Do you have the dowels that coincide with these? Whats the depth of these cam locks? Thank you!

I'm trying to find replacement channel balances and top sash guides for my windows. The home was built in 1990 and has Alcan non-tilt windows. Almost all the channel balances and guides are broken. The channel balance is 1/2" and 29" long (not including the shoe and balance top)and is marked 284 ... (cont.)

I would like to replace one Pennsylvania House dresser drawer stop. It's for a purely Stated II model drawer dresser, model #20-2601. See photos. Please tell me what part to order and your cost. Thank You, Jeff

This part had a 3 1/2" center.

Hello I'm looking for a wheel that is missing from the right hand base support of my kitchen cabinet garbage pull out. The hardware has only one very small label on it - Unigrass 8000. I have included three pictures. 2199 shows both bottom brackets with the wheel missing on the tirhgt one. 2200 is ... (cont.)

Any chance you can locate this door hinge? I need 4 of them...

See attached picture. It is the left rear mounting bracket for a Grass 6600 Series slide. It was installed when the house was built so I assume it is about 15 years old. It finally failed. There is not much room between the rear of the drawer and back wall of the cabinet. The protrusion is on ... (cont.)

I have Scheirich Kitchen Cabinets and several of the plastic rear tracks have broken. What would be the best replacement. There is a metal type plate screwed to the back of the cabinet and the tracks fit on, there are no scres

Looking for this handle set

I need to order the RIGHT side replacement because the plastic broke. While I am ordering I want to order a LEFT side version as well.