Viewing all customer Discussions for:

Other

Can anyone help with replacing the attached window tilt latches? Any help is much appreciated!!

There are no markings. The last picture shows a Barton Kramer 713 on top. It is slightly larger and will not fit into the door.

need 8 ATRIUM side load Sash Window Channel Balances 9/16" Diameter metal channe alone is 29 inches long, WINGED top guide beige-colored, NON-winged bottom shoe, beige colored. No serial number, nor any number. The windows non tilt, are 36x60 inches and were built in 2005. The bottom shoe is 1 1/8 ... (cont.)

I need to order two channel balance for my window. Please provide me with ordering information. Thank you

Looking for an equivalent bead. The bottom leg that touches the side of the pane is 3/8, this has a small amount of adhesive where it touches the side of the pane. the slanted back of the dome is also 3/8, this part touches the front side of the glass. The window pane is 1/2 wide. snaps in place. th ... (cont.)

Looking to replace the pile weather stripping on my windows. Don't know what size. See attached pictures. Thanks, Dave

24 inch 2320 stamped in metal circa1980. Also née plastic pull out release stops as In photograph number 5. Yellowed plastic parts are the original, grey newer parts are ones I installed and do not fit channel

Need to know will will be a compatible channel to replace BSI 2140 with the ends shown in the picture

This operator got a bit "sloppy" and I was able to adjusted with a hammer. But I would like to replace it . The long arm is about 11 1/2 inches long. That's about what I know.

All, See pics - I would like to replace the handle and locking plate (?name) for window - color is white. Please help.

I need the window seals for Kolbe casement windows that crank out. I think it is 2/8", but it is torn and distorted.

Have 7 ft wide door, looking for new rollers, over 20 years old, hard to push open

I'm replacing some series 770 balances and pivot shoes, and i discovered that a metal piece on the window that fits in the pivot shoe is broken can you help me with my order

I need a replacement part number for an Atrium 26-3 LX CMC 11 balance with a channel length of 27". I also need the part number for the plastic stop that attaches to the top left inside channel of the window but there is a 5 photo limit so I will submit it on another post.

Age is unknown. If original to the house, they're from 1973. Boot slides on a track bar. Total extended width shown in photos. Casing on the sill is easy to remove. Thanks for any help that can be provided.

Need 2 parts for window sash. One on the top of sash to left of sash guide (see first photo) and the other is one second photo - it is on the edge next to sash guide and has some bushing, Thanks in advance, Mike

Part R30842 entry guard truth

This is the only nylon bracket on the closet door of our RV. There is no metal casing.

I recently replaced both 81-112 door rollers and the 6' door track. I have adjusted the height up and down many times but the door is very slow and sticky. I have also used your recommended slide lube. Please help. Any suggestions?.

Tilt in Double hung window - no identification on glass or stickers New home owner also