Viewing all customer Discussions for:

Other

I was wondering if you carry this part. Please advise.

The hole is approximately 1 inch long. The builder never installed, so I don't have an example to show you.

i am looking for what i believe is called a sash balance, or saah lift mechanism for this window. there is a patent number on the side of the part, that reads #5w37877. the part consists of a fiberclass, or plastic rod, that runs down the inside of a coil spring, and connects to the block that the p ... (cont.)

These hinges were installed on custom cabinets, probably in the 1980's. They are stamped with Blum on one side, and 130.210-01.22 on the inside. The cabinet doors are in great shape, but the springs on some of the hinges have given up after all these years. The dowells for the screws are more cent ... (cont.)

The small plastic piece is I believe a top sash guide. This one is from the good side and the other side was broken. The channel balance's have the following numbers on them. 26-3 HM5 CMC 47. The metal on the balance measures 27" and with the plastic it measures 28". The balances are 5/8' wide ... (cont.)

I haven't removed it yet, but attached pictures in the hopes you could help with a replacement part

Dear Sir/Mam. We need to replace the channel balance in our double hung non-tilt window. Channel width is 1/2" and channel length is 32". We need your help to identify the correct replacement part. Please see the attached phoots

Hi , it says 703 on the part. Would you happen to have it? Also the seal too

Please email me if you can identify this part. I need 10 pair (maybe more)

I order a 4-15/16 door handle but it's to big. I need a 4-15/16 . Not sure where I can return it . Really all I need is the litter plate that cost 6$ or so. Can you help me please?

Can i order a take out clip? I want to replace the balances in the window but one side no longer has a take out clip

I'm looking for replacement for 7073B R. I also need the left hand version. I've read the blog posts, and it seems like 39-094 is a good bet, with the track mounted under window casing. But, the arm is much shorter than the 11 inch arm on the original 7073B arm which is 9.5 inches. Is that differ ... (cont.)

Hi... I found your site because I needed a couple crank handles. When I went to open the window and I realized it was rusted out and the top hinge that keeps the top corner of the window and place fell off and broke (see pictures 1 and 2). Can you please tell me what part I need to replace it?If you ... (cont.)

Need two roller inserts for my mirrored closet door. Insert measurements:roller 1 3/4" diameter, w 1 5/8", h 2', d 1/2"The roller has HC Corp on it.Thank you,Ed

19 2 Caldwell 1/2x 9/16x 20' LG.

Hi, Please see attached photos. Do you have the plastic trim shown? It fits inside a channel of the metal frame and it's for holding the screen (installed outside the broken fin) in place. Thank you for your help!

Measurement 35" length Width = 9/16" Stamp on balance = 3430

Can you help Me complete a replacement window job? The installer left out the lower vent plugs. Thanks, Andy

Replacing the coil balances for a 23 year old bathroom window. The coil is 1/2" wide and is stamped with 64C. From your coil replacement page it looks like S190. Can you tell me which one I need?

We are looking to replace these pivot shoes. They are designed for interchangeable inserts, but the replacement doesn't need to. It just needs to work with our window.