Viewing all customer Discussions for:

Other

Hello, a drawer in my kitchen got stuck and sort of sank into the frame. Then I noticed this part fell off when I pulled out the drawer. I think it says PMC on it. Do you carry this? I think the cabinets are from the 70s or 80s. Thanks!

Balancer printed "24 5 TO CALDWELL metal to metal measurement is 25".

I need the window balance for this alcoa window. How can I get some.

Need 2 left (?) side pivots for window panes.

Window block tackle block sash Need to order and figure out how to measure the length. Thanks Tami

Hello, please help. The plastic piece hold the metal pool which connect to the locker is broken. How do I replace this part and where can I find it? Thank you very very much.

entry gard truth20810A right 9inch

HAVE DOOR HANDLE THAT HAS CRACKED IN 2 PLACES. 10 INCHES LONG 2 SCREW HOLES 4 INCHES APART, HANDLE ON THE RIGHT. LOCKS WITH A LATCH. NO KEY

Do you sell this type?

Please advise which part this is for me to order.

My lower window was recently replaced with new glass and now it will not stay up. The new window weighs 26.5 lbs. The existing 2 coils appear to be 8 lbs each. Options?

I don't have a photo of the part because it fell apart when I removed it. It is the same size and design as the 40-022 except the rim on one side is not as wide as it butts up to the head frame and it is white. I've attached photos of the hole in the frame head and that for the sill. Both holes a ... (cont.)

I have two windows which are more difficult to slide up and down now, and one window which drops down indicating probably a broken tube. Need your help in identifying which tube to order and which shoes for replacing. Would appreciate some input.

I need replacement parts for a uniframe window company. I am working on two windows. Both need replacement window tilt latches and both also need the parts at the end of the strings

the locking mechanism doesn't work anymore

This is one part but you can see that its broke. The windows are 40 years old. the whole piece is missing the cam. Can you help us ?

Hello, I am hoping you can direct me where I can purchase this hardware. The house has Truth windows. But these windows have no tags or plaques. The piece I need to replace have no markings or numbers. I'm stumped . Please help!

Looking to replace a couple of 13.5 inch operators. The arm has a factory bend in it and looks like the gear is part of the arm? Couldn't seem to find a part # on the arm itself.Thanks!Mike

Hello! We have a single-hung Alenco aluminum window, 46" wide x 58" high, original window from 1989 construction. Attached are photos of the window taken from the inside and outside. The mechanism located on the left and right sides of the window frame no longer hold the window in position when it i ... (cont.)

I need a replacement "keeper" for Pella 350 Sliding patio door.