Viewing all customer Discussions for:

Other

Looking out window. Its the right side top hinge. NAMI NFRC 100/200 CODE HII-1 RATING NFRC SERIES CLCASE MST 2650 NFRC HII-1-006-7/ 14-15 97-M

I have bifold door that came out of a closet in our bathroom. It was removed a while ago and was not the one that removed it. I installed the door in another room but don't know how it is suppose to be assembled. The part I am trying to figure out is the top pocket socket part 23-307. When I t ... (cont.)

Hello, I need some replacements. Please see photos. Thanks, Marcus

HiI am looking to buy a pair of balancer for my windows. And 4 take out clip Code: 16-002The stamp show 27 3. When I measure the length metal to metal it about about 27 3/4. Let me know if u need any other pictures. Thank you Sean

Would you have an operator similar to the attached drawing? I would need a right and a left.

no markings on lock- not sure window brand top mounted not recessed rounded corners on one end 2" screw holes 2 15/16 long 11/16 wide Can an universal latch work? can replacement e wider as long as screw holes match up?

I'm looking for a replacement vinyl sweep for my shower door. Drip tray and sweep are shown in the attached photos.

I am looking to replace several channel balances and attachments in my apartment. As you can see in the attached pictures, the length of the channel balance is about 32", and the width is a little over .5". One of the balances is stamped 31-3 Caldwell JL, and the other is stamped 31-4 Caldwell CM. ... (cont.)

Do you have a replacement for this part?

Hi,I have two 20 year old Scan Furniture Chester Drawers that need new ball bearing sliders.The original drawer hardware is approximate 12 1/8 inches or 31 cm long and 1 inch wide.The unique feature are the two pegs that attached to the drawer; one in the back of the drawer as well as one beneath th ... (cont.)

I am looking for 1 pull to match this one. The Haas cabinets were put in our house 50 years ago and are still in very good condition. We want to keep the cabinets in place but need just one pull to restore them fully.

Hello. We just bought a new home, and our old Anderson sliding doors could use some upgrading. All the plastic stripping in torn and on the outside of the doors the stripping is misshapen and could be replaced if possible. Also we need new door pulls and the door is hard to open. Do we need new whee ... (cont.)

I am look for something similar to this. 8.5"-9" shaft. And a compatible handle. Also look for the lock handles as well. Thanks for your time, I look forward to hearing back from you

Dimensions: 2-3/4 long, 1-3/8 tall, 11/16 wide, 1-1/4 wheel

I had to break in because I locked myself out. Pried the window open and now can't close all the way.

I talked to someone earlier this morning but have had trouble getting the photo to this post but here it is I think. The picture is of the 34HD The windows were ordered in 1987 I need to replace following balances: (2) 34HD TS8 (2) 36HD TS8

Hello. Pictures are above and I am in need of a top pivot that matches the one that is broken/missing parts. Hopefully you can lead me the right direction. Thanks, Dimitri

I am unable to find this part. Thanks

Hello! This is the hardware on the top of a wooden sliding door. Can you help me identify it and find a place to supply a replacement? Thanks for your help!

We have numerous aluminum replacement windows in our house, many of which require replacement of the vinyl (PVC?) strips that run within aluminum channels between the sashes, as shown in the photos. These windows were installed by the prior owner of the house, so we do not know product info or when ... (cont.)