Viewing all customer Discussions for:

Other

I have hinges that are stamped PAT 1967 CAN. These hinges are being used on raised panel doors where the edges of the doors are back beveled approx 30 degrees

I need two plastic lock covers. It is about 2" long and less than an inch wide with a square opening on the bottom at one end that fits over the square peg in the window. The cover turns to open and lock the windows.

need 31" and 39" balance with 19-004 top guide for rollyson widow

I have a bearing that broke unfortunatly the staple went through part of the designation all I can see is R-40_2 the patent # 3207187. If you point me to a vendor or sell direct either way I'm tired of having it fall out. Thank you.

I need to find out if you have these balancers and if so $$. Also, want to know if i can get at local hardware store. Thanks Mike

Do you carry this model?

Have a 24" long block and tackle ballancer needs to be replaced

The handle holding protruding "plug" on top, through which the connecting screw to the handle on other side connects is broken off. the model # are series; 5621/5631 AAMA /NWWDA 101/I.S. 1-97 SGD-C30-96X96 SGD-R20-189X96 SGD-R20-141X96

Looking to replace a missing vertical vinyl glazing bead on a Louisiana Pacific window. Attached picture is a snapshot of LP stamp on one of the windows, house was built in 1997.

how do i know what length to use on window channels . they were replaced years ago . but never worked correctly. now they all have sprung..

Tried filling out form it would not send so I was directed to customer care. See attached pictures Windows will not open or close easily. The window frame is metal with hurricane glass. The sash weighs 30 pounds. I am not sure the correct balancers were used upon installation of the windows. W ... (cont.)

The Weathershield spring is stamped 32R. It was most difficult to remove, is there a better replacement? Dan S.

One balance broken. Other side likely to need replacement. Another window balances same size probably should be replaced.

Have a PPG Herculite (#'s BS 6206-1981-A and 16CFR1201/C11). Need to purchase complete handle/latch/receiver assembly. Where do I go?

I'm not sure which model I should buy for my window channel balance. The stamp says "26 5 GV CMC 7" as the photo shows.

My window channel has a 26-4 stamp on it

Storm screen door indoor outdoor door handle. Need Two

The turning part if the window locks are broken off. The previous owner had dementia, and probably broke them off trying to open the windows. I only need the turning part of the lock mechanism.

We have Windows from the Slocomb Signature 8000 series vinyl double pane windows that were installed in 2003. The piece where the turning part of the window lock (on the lower pane) attaches to on the higher window pane has fallen out of several of our windows. I would love to find replacements! ... (cont.)

Hi I need replacement snap in glazing for my window and I can't seem to match what I have to what you offer, can you take a look and see if you have somthing that will work? The size is 1/2" x 1/2" I attached pictures. Thanks Michael