Viewing all customer Discussions for:

Other

Needing help finding a lock mechanism for this sliding glass doors, no name or numbers have been located to find a lock. Any help would surely be appreciated. Any questions just email me. Thanks

Short coil has a C on it. Long coil has a CL on it. Sash is vinyl with thermal pane approximately 26" by 33"

Hello, I have a sash with portion of the vinyl window near the pivot bar support broken. (See attached picture. This does not have a separate pivot bar assembly). What's the best method to fix this? Will things like Vinyl repair kit work - this window uses S795-33D channel balance? Thanks, -Jacob ... (cont.)

Good morning. I was hoping you can help me find this window locks unfortunately I don't have a manufacturer name or part number for this. Thanks in advance for your time and effort.

is the 21-028 door guide pin round or square at top of the spring. i think it needs be square

The numbers I have is 20 2 bsi 0j

Looking to replace sash hardware for Lincoln windows including Tilt pin (SKU LDH67), Tilt latch (SKU LDH342) and Sash lock (SKU LDH677) (White). Any guidance on appropriate parts to order?

shower sweep rubber needs replacing - it is squeezed by the part in the install photo - ignore the black rubber - it was a piece I tried to use that was not long enough.

Looking for top adjustable guide for sliding mirrored closet doors. This one is fine but a few are broken.

What can I use to replace this broken bracket? I see it is a discontinued item

Hi, are you able to help me locate the correct part #'s to order the hinge arm and window crank for a silverline 80 NCW2 2 lite casement full - Silver Stripe ID SS-20-76378. Please let me know if you need any additional information from me. Thank you!

Hi Swisco, I need a set of rollers that can work in place of those in photos.Thanks, Byron

I am in need of a window tie-bar and the three guides that go with it. Based on my research I think I need what is pictured below

As you can see I need a multitude of parts. 6 tilt pins. 4 left tilt lock/releases. 4 right tilt lock/releases. 2 single spring balance/shoe assemblies (blue). 4 double spring assemblies (blue). DBA StoneRidge Construction. I've installed replacement windows, mostly Alside, for over 30 years. 100's ... (cont.)

Hello, I need 2 sets (4 balancers). Stamped 34-3. AA. CMC. 11. See pics. Steel part, not including plastic guides is 35". I've ordered and installed similar balancers from you. I just want to order the correct part. Thanks

Channel balance series: S351 Channel length: 45" Channel stamp: 4530 Quantity: 8 Comments: These balances to replace double balances (two each side) supporting a window sash that weights 50lbs

We have a Pella Storm Door that needs the handle and springs inside. We have tried to find them at Lowe's but nothing is the same . the numbers on the bottom of the door are 16 CFR / 20 / -1,11 6/01 Please tell me what to order.

Can you get 11 inch Pella.

Hello I'm looking for the rear and front bracket for the depicted drawer slide in the photos.

Hello,We need to order two replacement channel lifts for the Caldwell 38 5 FS in the photo attached. Let me know if you need any further information.Thanks a lot,Mark Eagle Harbor Const.