Viewing all customer Discussions for:

Other

Good morning, looking for a patio door latch, i lost the key

26 inch window balance where the shoe has and the part that slide along the frame have disintegrated. I'm not sure if the entire balance must be replaced or just the show and sliding part.

The attached pictures is for a left handed crank system (Active Co. NY) that I need to get three replacement. The measurements is 4" from left to right and the dept is 2 ½" inches

hi please see pics spiral balance old alu window 1992 it is 28" long, dia is 0.36" i am looking for two units with the shoe shown on the picture. it looks like orange end cap. do I need special tool to install it back. I ll buy one set and if it works I have a bunch of window to repair the bottom s ... (cont.)

Hi there, I need a replacement for the hinge in my photo. It's Mepla apparently. I was repainting some cabinets and couldn't get one out, tried to lift it with a putty knife and one of the wings broke off. Thanks !

For a Pella rolloscreen retractable screen door I need the latch receive. The door part is good but the receiver or strike onto which the hook attaches broke up.Thanks for your help.Mike

I need to figure out what manufacturer is for these two sash locks and keepers. I can't find anything on your site that looks like this. Thank you and I appreciate the help!

lOOKING FOR VINYL WINDOW TRACK REPLACEMENT. looking FOR ANGLE HARDWARE TO HOLD FIXED GLASS PANEL IN PLACE

Also, need information on a double coil 10

I have a customer who has double hung windows made by Vinyl Concepts. He is looking for replacement balance parts. The balance has cords with what looks like a pulley system. I've never seen them before. Also can I use a different balance system if I can't find the original system ? ... (cont.)

The tabs on the left and right latches have broken off. I think your part number is 26-243 for the left and 26-244 are the correct replacement parts. Also, would the replacement part number 26-471 for a pair of latches be correct?

Hello: Window expert!My Milgard windows casement dual arms are rusted out with total of 10 windows are affected which was installed in 2009. I have been looking for this parts for long but no duplication/similar found in anywhere. Would this Swisco part 39-393 compatible to my needs. Please help me ... (cont.)

I need to replace the operator and a new handle. It's made by Truth. Only numbers I see are 45301. It's 21.5 in long.

DNS 13/23 outside pull standard DNS 16 inside pull standard Would like to order complete with lock and key

Require assistance in identifying channel balance and sash guide parts for Milgard Window. I looked on all sides, including inside the channel balance and could not find any markings or numbers that would help identify the part. Other smaller Milgard windows in the home have channel balances with ... (cont.)

I am trying to find the replacement for my sliding glass door handle.

I need a patio door track, and hope you can help me with identifying the manufacturer of the door. I have over every part of the door for a name or number, but cannot find anything to help identify the manufacturer.Thanks for your help!Danny

The channels are 22 inches long. They are from Blomberg Series 450 about 1999. I need 4 balances.

Round pins keeping window in the channels are broken off. Need to find a replacement part.

Hi, i need these types of parts, the crank cover and latch