Viewing all customer Discussions for:

Other

I need a new 81/4 in by 11/4 inch metal door with lock and key for Pella patio door.

I am trying to replace the old window springs in my mom's 70 year old home. The current window sash springs are approx. 34 ½ inches long. I was trying to send you pictures of one I have removed. I will have others to replace that are for shorter windows. If you didn't get the pictures let me kno ... (cont.)

Need surface mount latch -white 3 1/2" length not including latch 1" wide 1/4" thick Latch 1/2"

Tell me if you have anything close to thisDave

I bought a tru bolt 301 series security storm door model # 4154600 that was missing the door handle. can you provide a replacement option?

The entire handle broke off which holds the locking mechanism

It's plastic Little over 38" long 1st plc , is installed piece pointed out by the pencil, second photo is I'm holding up a old piece or the new police needs to go and the third picture it's another one shows where it goes covering the spiral balance

Hi, I am trying to remove my window (one pane is broken and I am getting it repaired) but i am finding that the pivot bar (when window is tilted in at 90 degrees to floor) will not budge from the pivot lock shoe. it seems frozen in place (not surprising since the window is about 20 years old). an ... (cont.)

Can you tell me if you have this item in stock. It is a commercial window latch that requires an allen wrench.

Looking for replacement sash balance. Not sure which numbers are relevant. See picture

This is a rear dresser drawer guide, about 20 years old. I couldn't get all measurements as the tips were broken off. Thanks for your help in identifying the part number, so I can order a few. Ken

Hello - i have an old Pella sliding door that i was hoping to get new hardware for. Inside lock is separate from the handle. Pictures attached. Would prefer in brushed nickel vs. brass. Thank you, Joe

I WAS TOLD THIS WAS APROX 20 YRS OLD. WE ARE TRING TO GET A REPLACEMENT

have no idea how old this is. bought a condo and the crank appears to be stripped. cannot identify so that i may get it replaced/repaired

Hi What is the part number for the Tilt latch for attached vinyl window? Thanks

My original sliding door was made by "Cross" put in 1976. I need rollers that will fit this particular door. Thank you

I have a JEeldwen patio door. The screen rollers are rusted. I need new rollers. Can I get the parts through you and what size or number are they part number?

passage lock with 2" backset (for atrium door) Prefer lever style, but knob is acceptable.

IMG_6556.jpg

Looking for inch and one quarter window glaze . The window uses BSI 34B balancer with the 15-169 snap-lock pivot shoe if that helps.Thank you .Ray