Viewing all customer Discussions for:

Other

Looking to replace screen door hardware

Are these old hinges available. 1980's Merillat Formica cabinets

I know you carry the part on the drawer bottom. Do you carry the nylon piece that goes in the end of the slide attached to the cabinet?

I am looking for a replacement for a Republic Casement Window locking handle. Measured on the outside it is roughly4 3/4 high, the screws are 3 7/8 inches apart. Please note that the photo is of a right side window, I need the latch for a left side window.Thank you for your help.Robert ... (cont.)

I don't see this on your website. 5/8" wide, 7/8" from the top to the center of the bottom screw hole. 1/16" to the upper screw slot.

I'm looking for the following replacement handle

My boss purchased a rental house with these windows already installed. Unfortunately, they will not stay in the tracks, and the lower window pane has actually blown out of the track and onto the floor if not locked in place. She needs hardware for 7 sets of windows, all identical. Could you pleas ... (cont.)

Not sure if it is one coil or two. Looks like it snapped but not sure. When I pushed up the window, I heard a snap. Both sides of the window looked the same. This is the removed piece from one side of the sash.

hello - i need two guides like what's in the attached pics - pls advise - thx, norm h

I found a serial/model number in the door pane CCMC#12765-L. The locking mechanism no longer works. I assume its the mortise lock, but the door does not have an external keyhole, only a latch inside the door. From end of top screw to the end of the bottom screw is 4.5". The length of the lock is ... (cont.)

These are balances for 20 - 25 year old Jeldwen windows (I think they're all single hung). I think they were considered a "contractor series". They're not the greatest windows, but doesn't make sense to replace them on the cabin they are installed in. Hope you can help with new balances! Let me ... (cont.)

I have 2 aluminum single pane windows in a garage that have some damaged vinyl snap in glazing beads. I have sent pics. Do you carry the replacement parts? Thanks

Hello, I have a non tilt window that I need balance and shoes for. Not sure what exactly I need. 29" tube × 3/8in diameter with red tip.

The track warped and then broke when I tried to straighten it. Can I get a replacement?

Have double hung Lincoln windows installed when house was built 1996. Windows mounted with vinyl compression jamb-liner & balances. One bottom sash the springs broke off (a few weeks apart); from what I can see the compression jamb-liner shows no damage. I am looking to either replace the spring & h ... (cont.)

Parts and instructions needed for replacement

Hello, I need to replace the seal at the bottom of the sash on several windows. I am not sure what style of seal and what size would fit in the groove and still be thin enough to be able to fully close and lock the window. Please see pictures and let me know your thoughts and what product you may h ... (cont.)

Inside Storm window out of Mobile home. Possible a Phillips. Swivel corner broke on bottom sash.

Hi, I need to replace 4 counterbalance pieces for Milgard windows. The number pressed into the counterbalance is as follows: 86-27-4 GM5 CMC 87. The attached Photos show the old counterbalance part and a sticker we found in the window. Can you help? Thank you!! Catherine

[No content]