Viewing all customer Discussions for:

Other

I have several top sash guides that need to be replaced.

Need handle for storm door #P6400332.152150121

Looking for replacement parts for old window operators. Only marking I can find is WARE MIAMI,FLA which is printed on the cover to the handle. I have 9 of these windows in an old building we are renovating and would like to save the windows. The operators are in varying degrees of disrepair. ... (cont.)

looking for stanley part number 00-5024

I believe the operator is in good shape. I want to make sure I get the correct replacement.Thanks YouJoe

We are looking for several latches that are no longer available through CRL. I am attaching a copy of the part identification from them. Please let me know if these are available or you can find a replacement part. Screw pattern isn't necessarily a requirement as long as the latch will work. ... (cont.)

there is a 9 stamped on it

Door Weatherstrip. Where can I find this?

Hello. I'm looking for either a guide pin or pin cap with a half inch diameter. Do you carry this?

041/1

Commercial entrance door steel Gap big enough wind blows inside the building. Top of strip has no gap 4 feet and below strip worn out and air comes inside Need replacement

Channel length is 26 and 11/16th inches Stamp printed is 26 4 Mfr by Milgard Mfr. H-LC30-48x78 Will need 2 balances

nees 4 of them Lawrence 7813001729

Equivalent to the side mount pivot bar, but the part that sticks out is pie shaped. Actually is a Loewen double hung. Could provide a pic with email

33 in channel. 1/2 in width. Stamped 32 4 LV CMC 0. Milgard non-tilt window. The hook broke off. Need 4 balances. Bottom looks like a 15-004 based on size.

It came off of a sliding glass door.

Has a "A" stamped in the cup. It has the numbers 244.3493 stamped on the back side of the hinge piece that fastens to the inside cabinet side.

We are unable to remove the door to find actual part - this is a picture of the sticker on the door. The door is approximately 30 years old. Any help is greatly appreciated.

What rollers will work with your bottom roller track, item # 23-272. I purchased the track last month but the rollers attached to the bypass doors do not set in the grooves in the track. The bypass doors are wooden and about 1 1/2"thick and probably 20 yrs old. The closet features a bottom track ... (cont.)

Need casement operator and related parts, white handle/cover, guides. Pat. No 4,840,075. Made in USA