Viewing all customer Discussions for:

Other

Wish to replace this with a folding handle so my blinds will clear the handle. Thanks

The original balance is top in both photos. Stamped 2930. Shoe has shallow angle. Original single sash window in Maronda home built in 2006.

Repair guy came out said we need to please pin. Do I buy the whole lock? Or can you just buy the pin?

We need the lock hardware for two patio doors. No Manufacturer information. The townhouses were built in 1967 in Petersburg Va.

We are looking to purchase replacement parts for an inoperable window in a Beauty Salon here in NYC. We believe the windows in this Salon originally came from Europe. Would you be able to determine the manufacturer and be able to obtain the parts? Currently the lever handle does not operate the wind ... (cont.)

I need a count of 4 of balances that are shown in the pictures.

To Whom It May Concern: I'm looking for a replacement Pella storm door keyed lock just like the photos I have attached for your review. The storm door is hinged on the left-hand side. Thanks, Steve

CHannel leaght is 23"

I need two sets (2 left and 2 right) of replacement balance shoes, And 2 replacement pivot pins. I believe these were manufactured by Alliance Window Systems approx 20 years ago. If you have replacement parts, I would like to purchase.

looking to replace balances in Marvin windows

I have a simonton window pivot shoe that needs replaced,please provide parts numbers and pricing.

Please help me identify this part#

Stamp 23 4 EW CMC 10 Channel length 24" Thank you!

I have these sliding glass doors with bad rollers, the bearings are shot. The doors were installed around 2000. The roller appears to be nylon and I can't seem to find a way to remove the old rollers

The lock works, it is the latch on the jamb. A thin strip of the aluminum jamb runs parallel to the door it had some type of catch attached to it that fit into the door opening. The standard jamb mounted catches art to wide for the opening in the door and cannot be modified to work ... (cont.)

We have old aluminum windows in our church. The bottom pane tilts out from the bottom. One of the latches is broken. It looks like you might have a replacement available. The hole spacing is 1 3/8". Is there any other measurement we need to do?Please advise.Thank you,Peg

here is a picture of the original channel balance. You will have to enlarge it. The top channel balances are labeled 28-c. The bottoms are 26c. The hook has to fit into a hole in the trim behind The channel balance. inside a small hole in the trim.

Metal insert (from window frame corner) to t-lock balance open cam17-084 PNThis looks like the metal tab that is rusted beyond recognition in the corners of my sash frames and which fit into the t-lock cam device on the end of the balance.Have you got a replacement or work around?.Thanks Pat ... (cont.)

Looking for this replacement part, it's for a smaller bathroom window, it's the mechanism that keeps the sash in place/open. Approximately 28" long, total. Looking for the entire mechanism, wound part, stopper and metal sleeve. Thanks

Windows are made by HARCAR. Size 1/2" x 1/2"