Viewing all customer Discussions for:

Other

These plastic parts hold the window closed

Jalousie Window OperatorMeasurements:Between top and bottom holes - 5 1/4"Between bottom holes - 1 1/8"Arm length - 2 1/2"Width - 15/16"I am in need of 6 units of each of the parts listed in the Subject l

I am trying to make sure I have the correct hands and hardware to fix my windows. I have attached 3 pictures showing the setup I have. I would like to replace the crank and the casing. The handle just comes out and I am assuming its not supposed to do that. I think I may need the arm as well. My ... (cont.)

Is 39-091 or 092 the correct replacement part for crank in pictures ?

Looking for drawer guides this size 1 1/2 inches long 1/2 inch wide. Can you help me out. Thanks Paul

I'm looking for latches to fit my windows. The original one are broken From hole to hole is 1-1/8

How do I attach one of these swico screen turn clips to my plexiglass inert I need to replace them because some clips are broken. How do I remove the broken ones first Thanks

Hi the slider on top is 19 5/8", the one pictured on the bottom is 19 7/8". They are both white. can you identify a replacement part. Thanks for your help

Hello! I'm looking for replacement parts for some old casement windows (probably 1980's ish) One of them detached from the hinge causing the window to just hang for a couple months - then finally a strong wind gust ripped it off completely. Remarkably the window itself is still in tact, I think I ... (cont.)

Please see attached. I cannot locate replacements. They appear to be 1904/4904 but have nylon wheels. The nylon wheels are press installed. Any help would be much appreciated. Thanks.

old patio doors. several in the home i purchased. going to need 4 of these. no names only says japan on back.

Please let me know what roller will work for this replacement. It is 1 inch wide. The wheel is 1 1/2 wide. The frame is 2 3/8 long. Is it possible to get a replacement wheel?Thank you,Audrey

Door label - Seriers 5000 fiberglass SGD P.L. #549-014 Knob to lock the door from the inside is missing - we are fine with and entire handle replacement

I'm looking for Snap-in glazing beads for my EPI window and sliding glass doors that were installed in the early 1990s. I need a left side and bottom piece for my window which is 58" high and 70" wide. I also need 4 - 72" side pieces for my sliding glass door.

Need replacement handle; trouble finding color match. Thank you!

BD 16 7x27 2-87 is one number on back other is11600-17 What replacement parts should I be ordering

Here are several pictures with measurement of the replacement part I need. I think it may be 39-417 but I want to be 100% sure. Thank You Gary

Marking 110-01-R

Closet frame top support bracket for thin bi-fold closet door to fit roller guide HDI 4040J. Only marking on door is B410L. Closet doors are only 1/8" thick made of heavy duty cardboard. Never seen this before. Support bracket I'm looking for is color white 22 3/4" L X 1/2" wide. Slot is 1/8". Thank ... (cont.)

This wheel works but the adjustment screw and nut are missing. I can buy the whole thing or just the screw and nut.