Viewing all customer Discussions for:

39-099 Andersen Awning Operator

I am trying to replace a crank. The parts numbers I can see are F-9400-8A, C-9400A. The teh shaft is 8 1/2" long and the base is 5" wide.

My Master Bathroom window (installed in 2004) is a casement that opens from the bottom. I need a new operator but the 3 11/16 width (as per the diagram showing measurements) of the unit is too wide, mine is more like 2 3/4. What part number do I need?

I need a C-9400A-1 straight arm left (i think). What part do you recommend?

The crank will not close the window. The gears skip when the window is almost shut

Ordered wrong part 39-099. I think I need part 39-264. Attached pic shows my old part.Please confirm

All I need is the little white piece ... do I need to purchase the grey replacement shoe? They look totally different is why I am concerned.

I've seen a lot of different information on Anderson Window Cranks on your website. My crank on the top reads C-9400A-1 and the bottom reads F-9400-8A. The windows were placed around 15 years ago. Do you have a replacement part?

Hi, Please help me identify the right replacement part. Here are the numbers and such-- 1521101 on arm Andersen 7227 on side arm High Perfomance CIG-3 3-95.6 IGCC CBA IGMAC 2.75" apart screws on operator probably installed in 1996 (at the same time as the other window that I am asking yo ... (cont.)

awning window was installed 1998.its a andeson the part that goes on the window no. is C9400-1...........the arm no. is1521101

I have Anderson awning windows throughout my home and this 39-099 appears to match my operators exactly. I want to know if there is a part that will allow my window to open more than the 9 or so inches the current operator allows. I have tried disconnecting the linkage arm from the window and ... (cont.)

Is there a difference between operator 39-099 and 39-343. I bought one with the adaptor plate, and I do not need to use the plate. After installing the operator, I cannot close the window completely, the arm of the operator is hitting the window sill. Any suggestion?

The interior gear parts are stripped. Help me find the right part please!

I am looking for an anderson part that is for a crank window. The part number I have is F-9400-8A. I have seen where there has been discussion about it on this site but how can I get one? Thanks.

Hi; I got the replacement crank arm today and I can't see any way this part will fit. The part is 39-264 was supposed to be the replacement for the awning window. My operator has a few part numbers.C9400-1 on the top, F9400-8B on the bottom and 1521101 on the arm. The arm is 9" from the center of ... (cont.)

Home was built in 1997 - would Andersen Awning Operator #39-099 still work for that year? If not - what awning operator would be similar to this for the year of 1997? I can't give you a photo since I am located in Florida and the house is in Martha's Vineyard. I know it is a single arm similiar to ... (cont.)

I have several old Andersen awning windows that have inoperable crank operators. Is it possible to replace the hardware with newer models since the exact replacement ones don't seem to be available? Does one have to remove parts of the sill to remove and replace the mechanism? Or should I just disco ... (cont.)