Viewing all customer Discussions for:

39-114L Crank Handle, 11/32"

I have rusted out hardware on my single awning windows. I have added pictures of the parts we removed. There are 2 locks per window, with the white levers. There is one hexagonal metal piece with a handle that opens the window. And there is a separate metal unit I placed next to the locking mechanis ... (cont.)

Hi, I need to replace a window crank approximately 5 1/4 from left to right, the arm is approximately 8 inches when extended. Do you have a replacement? Picture attached. Thank you!

Looking for the crank mechanism and arm for this left and right. Also the accompanying lock and bar for the right. Thanks

Can this handle replace existing handle on 39-031 and 39-032 dual arm operators? Bob

Hello, My name is Tom from Glass Doctor of Western Seattle. I have an order that I am trying to complete for a current client. These are single arms that extend on Right hand side (Inside looking out) I will also need a new track for these as well if applicable? We are thinking of an order for the b ... (cont.)

Window will not open or close completely when cranked. Crank is located on the right side when viewed from the inside out.

Hello, We just purchased a run down house and have noticed that a lot of the vinyl windows are going to need either or both their operators and covers. We cannot find any manufacturer names on the parts and would like to know what brand we need to buy. I will send a couple of photos of what we hav ... (cont.)

hello i am looking for hadle for windows

Looking for replacement parts if you have any

Truth Hardware Operator Cover and Crank handle 11/32" I need the insert that connects the handle to the mechanism under the cover.

Hello. I need a operator. I could not get the manufacturer of the window information. Measurements are 4" base 3 3/8" Arm 1 1/2 " top arm, connects to sash. Please advise if you can. Thank you

Hello- I'd like to get 4 pair of these type of hardware shown in the attachment.

I am trying to replace a stripped operator for a Silverline casement window. I am attaching pictures and the one part number I found is 30905. Do you have the replacement operator? Thank you very much

11 inch The bar is 11.25 inches long. The windows that I have have a channel at the bottom that a wheel rides in and they are rear mounted. Maybe a shorter arm might work? The height of the wheel is 5/16" tall and the groove that the wheel rides in is 9/16" wide. Yes I need 3 left and 3 right ... (cont.)

Top part on jamb and sill part are 10 inches Bottom on window is 7.5 Crank part is 5 inches

The name on the handle is "SEALRITE" The dimensions as best I can tell are 4&3/4" on the e3xterior arm and 5" on the inside crank. Numbers include 20755 on the upper arm and 31229 on the lower arm. Please not these pictures are for a window that opens to the left but the replacement I need is for a ... (cont.)

Looking for replacements of the plastic covers that go over the crank mechanism on casement windows. Mine are 4 inches wide and 2.5 inches deep I may also need to replace the handles...not sure.

Hello, we are looking for this Marvin Awning Operator, the arm length is 9-1/2" and it has a pivot shoe on the end that connects to a rail on the bottom of the sash. Please let us know if you have this. Along with the crank handle. Thank you.

Window Crank about 5 1/2 inches long

On the body of the unit: 40471, 25, 91. On the longer primary arm: 30470 LH. On the shorter secondary arm: L30841, 20810.