Viewing all customer Discussions for:

39-114L Crank Handle, 11/32"

Need replacement crank help. Respectfully Yours, Sanjay

1978 Biltbest casement window.. Evergreen, CO... 12" crank arm... 8" holding arm.. Brass/gold metal cover... Single phillips screw holds down assembly...4 3/4" cover assembly....

Id numbers on crank read 20755 on one hinge & the other 8589.they look very close to your picture of 39-156 and cover code 39107,I need 3 cranks & 1 cover. thank you Ken

Hello, I

Hello, The item I am trying to repair is a Biltbest part 233 D.C. I believe I would be allset with just the stem gear and the arm. Please see the photo.

I need to order a replacement part for my window. It

looking for replacement part for Truth left handed operator and arm: operator 45252 arm 40051B Please let me know if you carry this. Thanks Ravi

The crank is stripped out can you help me. Thanks Clay

Hi there, I have a very large home with Semco windows throughout and I am in need of two replacement cranks. I have included photos of the crank, the two I need are identical (left sided) and are stamped with a #19, made in USA. The crank measures approximately 5" in width, the window is approxima ... (cont.)

Hello - I have what I believe is a Truth operator for our casement window. Stamp number 40050 is on the arm extending from the operator to the window/track. Could you please direct me to the correct replacement operator? I also need a replacement crank handle, 5/16" Spline which has stamp 45240 ... (cont.)

looking for a right hand casement operator. the numbers on them are OP05-7553-03 with a time stamp of 10/17/03 15:19:47. on the arm op052020

I need to get a replacement hardware for my casement window ,the only number I could see in the main unit is 0p05-1505 ... The arms have different # each one (0p05-2017, 0p05-2016, 0p05-2019 and 0p05-2018). Please advise the correct part number to replace this defective part.

Hello regarding hardware for 6 awning windows. Hoping that you can help me identify the part. I am not 100 percent sure but may be a Marvin window. The number on the bottom of the mounting plate reads c-1081-101Thanks Carl

Hey, I am looking for casement operators for Norco D-series windows. The number stamped on the hardware is 076-N-330. They use the typical single arm truth hardware. The single arm is about 8-9" long (didn't really know where to measure it from.)

I'm painting Shelter window trim from oak to white and want to replace the window hardware from grey to white. Do you have any options now that Shelter is no longer in business and I haven't been able to find parts anywhere. Sizes and hardware shown in images. Truth Hardware logo is on the inside o ... (cont.)

I've included all info I believe you'll be needing along with the photo. Thanks.

What handles do I need for windows dyad crank 5

Operator ID Help

My name is milton Pls do you have this type of handle for windows id so pls advise . thank you and hope to ears from you

All of the windows in my kitchen have broken hardware, and as a result, I cannot open any of them. They are all casement windows with crank hardware and plastic latches. In two cases, the crank operators are broken and in one case the locking latch is broken. I have contacted a few handymen to se ... (cont.)