Viewing all customer Discussions for:

39-155 Caradco Window Crank, 9-1/2"

I am in need of a new window crank. On the handle it says KK so I'm hoping you can help.

This broke over the weekend. It will allow the window to open, but will not close the window. The entire case pulled out, and is broken where the handle pushes in. Thank you so much.

I am trying to find the casement window hinge with a number of 31538A

Need your help identifying and ordering both left & right sides for this window

The screw gear attached to the crank handle appears to be stripped and does not engage the gears to open or close the window. Do you sell this part?

looking for a replacement part for cranks with a label of 20810 as well as 6092 can you tell me what part i will need to replace the whole mechanism? Thanks

Hello, The handle rotates but mechanism is not working properly. TRUTH Brand 40471 0n mechanism and Truth ENTRY GUARD 20810, arms move properly. Thank you Alex

Hello, I am looking to replace 2 window crank mechanisms. One that opens to the left and one that opens to the right. The long arm measures about 10.5 inches from the end to center of the crank. The short arm measures about 3.75 inches. Thanks for your help! Mark

I have several casement windows that are most likely from the late 1960s. Operation is failing, and need replacement. Both left and right. Dave

Do you have a Swisco controller that will substitute for a Entry Gard Truth 20755

hardware is truth entry gard. these windows are 1994 vintage and i am told they are posey brand windows. the window has been used hard, blown open in past wind storms and do not operate well. hinge plates and arms have been bent. i dont know if operator requires replacement but feel like i shoul ... (cont.)

The arm measures about 9 inches. The house was built in 1960 and I assuming they are original windows. I am not sure of the brand of window as I didn't see any identifiers on it.

Someone cut the other arm, so not sure what I need but I also need the bracket the cut arm attaches to

I have 9 windows with this hand crank, the round piece at the end of the long arm that slips in to the guide on the window keeps slipping out of track. Can this part be replaced or do you have to buy the whole assembly?

I need to purchase a replacement part

Awning window with side crank. Spiral gear might be stripped. Doesn't stay inside crank shaft.

This part is from a truth window opening hardware set. The window opens but does not close because this part does not latch onto the parts that cranks. I believe this part got stripped due to lack of lubricant over the years.

hello I have two pairs of windows with these operators. Two have now failed and I would like to replace all four. They are "Entry Guard" 31538 and the one that is pictured also has a large "L" stamped on the arm.

Hello. I am looking for replacement mechanisms for left & right windows. One of each (2 windows total). They are Brosco windows installed about 33 years ago. The round flat gears are stripped on both windows. Please help!Thanks Much,Jack

We have 2 old cranks that are broken. Both the same and likely original to the house 1974.