Viewing all customer Discussions for:

39-155 Caradco Window Crank, 9-1/2"

Gears are stripped or missing. Looking for left and right hand swing. Rod length is 9 inches

Is this the correct item (#39-032) to replace an EntryGard Dual Arm Operator marked 20810 and 30744 for left side window looking outside (see photos)? The teeth on the worm screw are stripped, so the crank only opens, but will not close.

Teeth of swing left window (viewed from inside looking out) are broken so window won't open. Need a replacement for it.

Please help. Need right and left

When looking from the inside out , need 3 that window opens to the left and one window opens to right. Long extender bar measures approximately 81/2 inches. Can you help me out.

Please identify operators and get me price. Thanks.

I need the right closer for this

I have Milgard crank out windows installed in 1996. The corkscrew mechanism inside the piece that the handle sits on top of which turns to let you open and close the window is broken. The picture sent shows the L31538 Entry Gard Truth. Do you carry this part? I am in need of two of them. Thanks ... (cont.)

Looking to find what hardware I need as our handle does not turn the "auger" to open of close the window. No clue what I need to order.

The window is Norco window. Do you carry the parts to replace the broken one in the photo

i need one for the left and right side of the window

The short arm attached to the gear has the letter R stamped on the top side and the number 31538A and the letter L stamped on the bottom side The short arm is 3.25 inches center pin to center pin The pivot arm that is attached to the short arm is stamped 20810 The pivot arm is 3 15/16 c to c The l ... (cont.)

I have a casement window that needs the dual arm operator replaced (truth entryguard 30744). The window swings out and to the left + has the crank in the center (not the type that folds down). Can you tell me the correct replacement part?

Hello- We have truth window hardware (we think from the 1980s) and the small part that goes into the crank handle appears to be damaged so is no longer catching the gear properly to crank the window open. Is this a smaller part we can replace or do we need to replace the entire operator system? If ... (cont.)

Any idea what this is and do you carry window crank. I have bought from you all befor

I have a list of operators and Cranks that need replacement. What number do you need off them in order to identify them?I need to order them ASAP. Please advise... Raymond

We are looking for this crank, but have been unable to find something similar.

The brand looks like "Truth" On the base is the number 403272. On the top arm is the number L30841 On the back of the sentry guard arm is the number 30470LH

Require placement cranks. A right and left crank.

The part has "Truth 30744" on it. It has a round part that goes in the slider, while the recommended parts on your website have either a square or rectangular part. Can you tell me which arm set would replace the one in the picture?