Viewing all customer Discussions for:

39-156 Caradco Window Crank, 9-1/2"

Please identify operators and get me price. Thanks.

I need the right closer for this

Would like to identify replacement part

I have Milgard crank out windows installed in 1996. The corkscrew mechanism inside the piece that the handle sits on top of which turns to let you open and close the window is broken. The picture sent shows the L31538 Entry Gard Truth. Do you carry this part? I am in need of two of them. Thanks ... (cont.)

Looking to find what hardware I need as our handle does not turn the "auger" to open of close the window. No clue what I need to order.

The short arm attached to the gear has the letter R stamped on the top side and the number 31538A and the letter L stamped on the bottom side The short arm is 3.25 inches center pin to center pin The pivot arm that is attached to the short arm is stamped 20810 The pivot arm is 3 15/16 c to c The l ... (cont.)

I have a casement window that needs the dual arm operator replaced (truth entryguard 30744). The window swings out and to the left + has the crank in the center (not the type that folds down). Can you tell me the correct replacement part?

Hello- We have truth window hardware (we think from the 1980s) and the small part that goes into the crank handle appears to be damaged so is no longer catching the gear properly to crank the window open. Is this a smaller part we can replace or do we need to replace the entire operator system? If ... (cont.)

Any idea what this is and do you carry window crank. I have bought from you all befor

I have a list of operators and Cranks that need replacement. What number do you need off them in order to identify them?I need to order them ASAP. Please advise... Raymond

We are looking for this crank, but have been unable to find something similar.

I need a replacement part for the crank system (not the handle) for a Milgard casement window. Thanks.

Require placement cranks. A right and left crank.

The part has "Truth 30744" on it. It has a round part that goes in the slider, while the recommended parts on your website have either a square or rectangular part. Can you tell me which arm set would replace the one in the picture?

Would need 2 right and 2 left

hello, i need to replace the shown window crank

Good morning. The window is located in a ocean community home so rusty is an issue. I need left hand and right hand operators, tracks and hinges. Hinges for top and bottom please. It's a bay window that still has the glass sealed. Amy help is appreciated

Dear Sir/Madam, I'd appreciate greatly if you could help me to indentify the parts that I need for the replacement of the crank assmbly for a casement window. The stampings on the assembly members are: "20755", "Entry Gard", Truth, etc. Let me know how I can upload the photos if you need them. Than ... (cont.)

I have 2 casement windows, both about 20 years old, where the roller/bushing is popping out of the operator track when the arm is cranked out to approx. the center of the track. Do you think it is an issue with the bushing/roller - or something else? If the bushing, is that available by itself? (par ... (cont.)

Hello Swisco, I have a Truth EntryGard operator wheel which is getting bound up on the track holes. The wheel spins freely, but the edge of the wheel is chewed up. I'm guessing the wheel is no longer the correct diameter and that's what's causing it to get bound up. I see the wheel is riveted on t ... (cont.)