Viewing all customer Discussions for:

39-258 VE Anderson Window Operator, Left Handed

Greetings- These are from 30 year old aluminum awnings. I can't find a name or number on them. I'll need 2 left and 2 right. Thanks for your help! Craig

Window was installed in 1998. 3 screws, 5 inches between screw holes next to drywall

Right handed On base says RD. 1963 Pat# 190208 Says-92 inside box

Hello, I'm trying to find a replacement for my window awning crank operator. It is 23 years old and was installed in 2001. It has C-11500-11 engraved on the inside handle. I measure the extension arm that connects to the window and it is 3 1/4" full length. Would greatly appreciate you letting m ... (cont.)

Please assist in purchasing right hand operator with offset arm length 2 5/8" with arm hole size 3/8". Thank you.

Trying to identify this

I'm not sure when the windows were originally installed, but I know they have been there for over 25 years. There are approximately ten windows in this Florida room, only one of which does not work. I am able to open the window with the crank handle, but when I go to close it, the entire handle (cra ... (cont.)

These are cranks for crank open windows that are also emergency exit windows. I couldnt find any name or numbers on the crank.

Window Crank

awning window operator with only two mounting holes. All help appreciated identifying.

Anderson 39-258 left handed crank I would like to order one for now. Please.

We purchased item 39-194 rh crank. The is clearly right-hand crank. We went to install, and new crank is off in arm angle just enough that it leaves a gap in window crank that it bolts up to. The bolt holes are also off from what are currently. Not sure where i go from here as i have 4 cranks that i ... (cont.)

I'd like to change operator from right side to left side of the window to make operation easier and safer

Pix 1+2 show broken off sissor hinge openers on North unit installed late 1970's 3rd pix shows intact unit which has scissor hinges as photoed on both sides of over n under glazings

Looking for help to replace the window crank and another part I might need. The windows do move freely.

The windows are from the 1980's in Florida. The crank has no markings or indications as to the manufacturer. I can not detach the crank arm from the window as they appear to be bolted on.

Hello, I live in Fort Myers, FL and during Hurricane Ian two of my awning window cranks failed and the Windows kept opening during the storm. Now the cranks are completely damaged and will not close the windows all the way. The original house plans show windows by Norandex (see pic). I called Norand ... (cont.)

Markings inside. Pat D-193202 with an upside down U . SRD. 1963 CAN or OAN. You can see the inside in 1 of the picturesAlso you will stamped with an HKind Regards,David

Unfortunately no model numbers, but I was able to find patent numbers. Just in case it helps, it appears to be D198-202 U. The base is L shaped with an offset hole. Vertical measurement between holes is 4-1/2" from the top hole to the offset one. Horizontal measurement between the two bottom ones is ... (cont.)

Good afternoon, I need to know which part # to buy for my jalousie window. I need the entire mechanism shown. Thank you,Zach