Viewing all customer Discussions for:

70-008 5 Pack, Screen Plunger Pin Latches, 7/32"

the attached photo shows the screen for my windows . I need to replace some lost push plunger . Could you advise if you sell such a replacement Bill

What is the metal of the plunger pins? Being located ~150ft in from the surf, all of the original aluminum pins of my MW Twinseal window screens, on the ocean side, had corroded and seized by the time I bought the place 5 years after being built.

I believe the Product Code I need is 70-009. Please see the pics attached and advise me what to purchase. Thank you.

Hi- I have Hurd window screens and need to replace the screen pins. I see you have model 70-009. Do you know if they will work as a same fit replacement pin. My pin is 1 1/2 Long but diam is 4/32(1/4"). They look close but wondering if the diam will be an issue or not.... Thank you, Leon ... (cont.)

I am not sure which pin I need, they are dry rotted and when I take out the few that I have they always break. They are about 4/16 on the end by 1 1/2 inch long. Thanks, John

Frame 3/8" X 3/4" Plunger pin clear 1 5/8" I need replacements Thanks

I'm looking for a lunge pin that is all aluminum, do you have any. The plastic cap on the regular ones becomes brittle quickly and cracks and breaks off. Thank You Cindy

I need a plunger pin for the screen of a standard Pella vinyl double hung window from Lowes. Do you happen to know if the 5/32 or 7/32 would work better?

Hi, please see the attached photo. I need additional plastic window plunger pin retainers for my Marvin windows as shown. I have the correct window screens, but I am just missing the little plastic retainers that need to be pushed into the actual window frame. This way, the plunger pins on my existi ... (cont.)

My window screens are setup with the 4 plastic tabs that are always breaking. How can I retrofit this top tension and possibly a leaf spring into the frame of the screen ? I was thinking a drill and a rivet set might be easiest but was curious as to what you would recommend. Many thanks ! ... (cont.)

Please help me choose correct screen pin replacement. Photo is of exsisting pin. It is spring loaded, 1.5 inches long. I do not know how to measure the diameter. Thank you.

Several of my screens have lost these spring-pin screen locks due to wear and sun over the years. i am looking for replacement pins so that i may repair my screens. Thank for your help.

Hello, Attached are all pictures of parts for the screen window. Please let us know if you do sell this.

I am looking to replace the spring pins shown below.

Is the shaft that goes thru the screen frame on the 70-009 and 70-008 the same thickness with only the top being a different size. I don't know what the thickness of the top on my old pins are. If the shafts are the same thickness then as long as the hole the top goes into fits the top I think eithe ... (cont.)

I believe the numbers represent the parts we need. Our screens and windows were installed last fall. They are hunter green.

I need a bunch of the window screen spring loaded pins that hold the screens in. Are they available?

I am looking to replace the 1/4 dia plunger pin in my screen , the sash is 1 inch wide. will your #70-008 plunger pin work ? I'm concerned the 1.5 inch length will be too short . the existing pin measures 1.75 length OAL with the plastic knlb in place . Thanks Don

Question for tension spring for screen. I have windows and screens that have tension bars with small pins attached to them that poke through the screen frame which then holds the screen into the window frame itself. These small pins have broken off the plastic tension bars on many windows. ... (cont.)

this is on the top of a screen it only goes through the frame to the spline track not all the way through