Viewing all customer Discussions for:

81-095 Adjustable Tandem Roller, 1-1/2" Concave

I have a job to replace rollers for a home. Built in 1957. Large single pane doors. Never seen these rollers with clips. Any ideas? Thanks

Need to replace the rollers on Guardian Patio Slider

I'm looking for replacement rollers for a Silverline vinyl patio door. Picture of label is attached. Thanks!

Hi, I need a new latch for this door. I've replaced it once already but don't recall the model number. I just need the piece inside. Not the handle. You slide the thumb latch down and it is suppose to lock the door. Mine is very loose. I also need to replace the bottom rollers. Can you tell m ... (cont.)

Decades old patio doors facing ocean. Don't know the sliding patio door brand. Single wheel assembly. Two screws on end, one to attach, the other to adjust. All 4 patio doors need their wheels replaced (no longer adjust, rusted solid, bearings destroyed, etc.). Question 1: can we use dual wheel asse ... (cont.)

No markings are found on the hardware. Each set of rollers (2 rollers per set) has and adjustment screw and a screw to attach the mechanism to the door, one mechanism on the right and one mechanism on the left. I have two sets of patio doors that need replacement rollers.

These photos are labels on the jamb of my sliding glass door. The door is becoming difficult to operate. I thought that replacing the rollers might help. From these photos can you tall which rollers I should purchase? I cannot have the door out of service for a long time so I want to remove it o ... (cont.)

A Google search for parts for an American Craftsman 5500 series door brought me here. The 81-095 looks like the correct roller (based on the rusted out one I removed), but is out of stock. Is the 81-030 functionally the same part?

I beleve this is a Del Mar F4161. It has 1-1/8 wheels. Two of these as soon as posible. Thanks Steve

Hi I need to replace 2 double wheel rollers for my balcony door as the currents ones seem to have lots the bearings over 25 years. Please see attached photos for reference. Which would be Swisco's model number? Thanks Lou

I need a set of replacement rollers for an Atrium Sliding glass door Series 312.

measurements are so close but neither has the angle at the wheel like the original but I'm not sure if that matters. Can you tell me if your 81-138 or 81-030 would be the closest replacement, please?

Product of Del Mar Eng Co Long Beach, CAL Need 2 for this door

I need an American Craftsmen Patio Door Tandem Roller Assembly Model 5800. Can you help?

Hello. I need to replace the lock and rollers on my sliding glass door. I need some help identifying the replacement parts. Thanks for the help.

Hi Folks, the existing rollers measure .750 X 3.075 and have 1.250 Dia rollers. I did order the Swisco part # 81-138. They do not fit into the channel, the rivit hinge is wader then .750. I would like to return those for the correct ones. The original rollers have a partially raised frame where the ... (cont.)

Greetings I want to replace the 2 tandem roller units on our Duplex Units vinyl patio door. The home was built in 1978 so I assume it is original wheel bearing rollers. I do not know the manufactuture of the doors it had Gallagher stamped in the glass corner but upside down. We had gone through t ... (cont.)

American craftsman sliding Patio door replacement rollers

I need 2, possibly 4 of these pieces. Please help!!! I have been looking for these for over 2 years.Carlos

The rollers are gone! I think the guy who replaced the glass walked off with them. Can you help?