Viewing all customer Discussions for:

82-227 Mortise Lock, 5-3/8"

Looking for replacement for a 32435 hook up align keeper

I need a complete set for my door and can not find it. I would like to get a key lock as well. The locking mechanism mounted to the door is bad as well. Thanks for your help.

Door handle IWC black

I'm looking to replace it with a key that can be lockable from outside.

Looking for the latching mechanism its marked as 2260 sash controls. the instruction sheet has 2262 on the top of the sheet. I think the latch spring has broken loose and the latch stays in the housing. Do you have a replacement part?

The door is wood and approx 1.25" thick. The only identifiable parts are the latch mech in the door labeled with Adams Rite Mfg, and the mortise plate with the pd logo. The inside thumb latch broke off the shaft that turns the latch. The internals are fine, just need handles that will work with th ... (cont.)

Purchased the 82-087 Legacy Keyed Handle set and the 82-227 Mortise Lock 5- 3/8". I installed the handle set and lock. I can lock the door on the inside but on the outside the key will not turn far enough to lock the door. However; if the door is locked on the inside I can unlock it from the outsid ... (cont.)

Here are 3 pictures of the handle/lock/mortise. I cannot find a brand but I think i need 82-310. Can you confirm? Thanks!!!

Can you please tell me which door lock I should purchase to replace the existing lock in the attached photos? Thank you.

We have a Windgate 3-Lite Patio door and would like to replace standard handle with a keyed handle. Screws on handle are 3 15/16 inches apart. On inside screws are 3 1/2 and 5 1/4 inches apart.

I am looking to replace a broken handle/lock for my sliding glass door. I believe the handle is the original from when the house was built in 1998. The door may be a Hurd but I cant verify that. The markings on the original handle says PAT#5,092,144. P/N 120-60. Will the legacy 82-086 work with t ... (cont.)

On the back of the handle on both side there is a few numbers,on top 2265,us patent 5125703 then D 340398 .please can you let me know which door handle can matches my old one and if 82-086 is a match.thanks for your help

Hi,I purchased this handle set with the 82-227 mortise lock 5-3/8 and it seems to fit just find. However the key is just spinning and not locking. What part am I missing or did I buy the wrong mortise?Kendra

Hello, I'm seeking replacement hardware for the attached images. We have a sliding glass door with a handle that broke after 14 years of use. Any assistance you can offer is appreciated! Nicholas

I need a replacement handle for my sliding glass door. The screw gap for this handle is 4 inches.

Handle broken

This came off of a door made by Wasco and they were bought out by a business that did not have any parts for these doors.

Looking for a replacement door handle and lock for my sliding glass door. SGD-R30-144x82 SGD_R35-96x82

We think the middle hardware piece needs to be replaced. SH-72-1 SH-72-2

I'm trying to replace this handle (Sash Controls 2260) in Black color. All I can find is the 2265? Looks like the 2265 is the same handle except the latch is offset on the bottom instead of the top?