Viewing all customer Discussions for:

S160-07 7.5 lbs Series 160 Coil Balance

I have a double coil window balance that is needing replacement. Each coil has seven on it so I assume that means 14 lb on each side. I am looking to get a match to this part. This part is approximately 5 in long and one and a quarter inches wide. I've submitted this post for the purposes of you see ... (cont.)

Need to replace in double hang window. Each coil was 7.5 (which seems) excessive with two on each side.

String #14 for window

I am sending what I need to replace broken coils for both sides of window. I wrote on paper, as you see, what is written on each coil. I would like to see if I can get the whole assembly, and cost.

Can you help me identify this balance? It looks like a quadruple Series 230 constant force balance. On your website, I only see it go up to a double. This one has a 33 lb stamp – 2 of the coils are 7.5 lb and 2 are 9 lb = 33 total. Let me know if it is possible to get this. Ticket # 36956183 ... (cont.)

One side coil spring broke would like to replace both sides but dont know what part to get

The lower part of the window weighs about 14.5 lbs, and its vertical length is 20 inches. Please advise me of the part size that I have to purchase. Thank you.

Window balance and pin also latch's needed for vynil single hung windows

Good afternoon, We were wondering if you could help us by letting us know if you have this triple coil balancer set from the 230 series. The three coils are 7.5 level strength. Please review the picture attached below and let us know if this product is available or if there is direct substitu ... (cont.)

Simonton windows, looking for the correct balancers to replace these. Windows very difficult to raise, or won't stay up. Right side looks different than left side.

Believe this is from an Atrium window about 10 years old. Spring has a marking that is 7.5# 35". There are some other numbers that are difficult to make out. The window weighs about 15#. The holders appear to be in working order but both springs are broken and bent. Springs are 1/2" wide. ... (cont.)

I'm looking to identified this coil with the correct pivoet shoe please can you help

I'm pretty sure I also need the 15-191 pivot shoe (for a 15 year-old Milgard Tuscany window). I also need the coil spring. The only markings I can find on the spring are #7, 5 35. Do you know what part that might be?

Hello. We recently moved into this home and have a window that doesn't open smoothly or easily. Attached are pictures of the window coil balance. Besides the patent numbers it looks like part # 801020 is the only identifier. There is also "B2" listed on one of them as well. Thanks for any help you ... (cont.)

Looking for the correct replacement hardware for the coil balancers on these windows.

Looking to replace coil balance and pivot shoe, but unsure what parts are compatible. Seems like this particular setup is either discontinued, or just hard to find.

I am looking for the replacement of a broken coil window balance. The number I see on it is 7. do not see this number in your weight list. The original is flat end, no narrow end or slot, only a round hole for the attachment screw.

Hello, I'm looking for coil balance assemblies for a California Deluxe Window. Thank you, Patrick

I recently moved into an apartment and my sliding window has started to malfunction. I had a handyman come over to inspect the problem and he instructed me to reach out to your customer service at Swisco and ask for new parts. The shoe seems to be tilted one side higher than the other. I’m ... (cont.)

I'm looking for a replacement