Viewing all customer Discussions for:

S380-15 15" Series 380 Channel Balance

what is the correct replacement part for this?it says 14 5 BW CMC 2I measured the metal length = 15" and width = 1/2"I want to buy 2thanksJon

I have Mercer vinyl windows with broken lifts I need replacement channels for 1 pair 24" window weight is aprox 19 lbs 1 pair 12" window weight is aprox 11 lbs 1 pair 15" not sure of the window weight just yet

Do you have these

Hello! When I took my window apart, it was missing the part in the pictures above on one of the sides. I need an identical part. Could you help identify which part number I need to purchase?

I think its from a Jenweld replacement window maybe model 8100 SH single hung

Please help me identify

Looking to replace the attached channel balances (one pair). I've never replaced before but believe I can figure it out. Thank you for your handy videos.Regards,Halle

I need replacement block and tackle for a milgard bathroom vertical slider. Window is ancient. Metal channel is 15"X5/8". Stamp reads 14 5 FT CMC 2. Lower window weighs 16lbs. See attached photos. Thanks

Our windows are M&M I believe. The metal portion is 15" long. The number on the back is 14 2 FW CMC 10.

Hi, I need two window balancers for a Milgard, single hung window. I'm guessing it is about 20 years old. The width is 1/2" and the length of the metal is 15". The following is stamped on the metal: 14 2 DO CALDWELL Thanks!

Hi. I have a window that has nothing to tell me what brand it is. It is aluminium. I need to replace 2 channel balances I have enclosed pictures of the one. Let me know if you have something I can order. Thanks, Kat

Hi can I please get help identifying this one? Stamped with 14 3 EQ CALDWELL Thanks

How and where can I get his part. The windows are 17" high Jimmy

I did not find any stamp and the only identifier I found was the 14 5 KR Caldwell, which I'm told by your forums isn't helpful. The length of the rod without the attachments is 15 inches long.

I have a 15 inch channel balanceWhat model do I need ?Thank YouLeo

The metal portion of the channel balance is 15 inches long.Which one do I need?Pictures are attached.Thank YouLeo

Hello, I need two of the 14 5 AS that ar 16" in total length. Where can I get them from?

The metal on mine measures 14 5/8? is it a 14 or a 15 the stamp on it is 14-2 bsi

i need a set for my pull up window this is the part i pulled off the window, can you tell me if you have this, thank you.

I need to replace my milgard balancer and get a replacement one. The text on the top says " 14 4 KP Caldwelll"