Viewing all customer Discussions for:

S380-27 27" Series 380 Channel Balance

I need the window balance the numbers on my old one say 26 4 BSI PD

There are no identifying stamp marks on the balance. The metal section is 27" long x 1/2" i'm hoping to get a quote for 6 replacements units.

The sash/string is broken on my non tilt Milgard window. The lenght of the channel balance is 27 inches.

Length = 27" Width = 1/2"

Fiberglass mobile home window... installed in a Cavco mobile home. Metal end to metal end measures 27". identified as 26.4 B.S.I. RK

1/2 Channel Balance stamped with 26 4. Im assuming that is the length and width. Several of the ID pictures online look similiar. Its hard to tell which ones I have.Can you also provide the part number of the plastic pieces found attached to the window based on what channel balance I have? or do you ... (cont.)

It says 2620 bs1. It's 1/2 inch wide

Hello, I have a few window channel balances needing replacement, they are marked as “26 4 BX CMC 11” and when searching for that I see 26” versions, but the metal part of the balance measures at 27”, so I’m not sure which one I should be getting. It appears to possibly ... (cont.)

Hello - I am looking to recommendations to replace these on 2 windows in my house. The small window one is marked 26 4 DN Caldwell. The Metal part is 27 inches long. The larger window is marked 32 9 BN Caldwell. The Medal part is 33 inches long. I appreciate the advice.

Hello, I am in need of assistance to determine which window balance is needed. I tried to take photos of the balance at a similar angle to what is on your website.

the channel is half an inchit is 27 inches long not including fittings 26-4 fa2 cmc 13 is written on the unit

Looking for non tilting channel balance. The only number I can see on it is 2630 the metal channel is 27" long and looks to be 5/8" wide

27" long, 1/2" wide

Need one(1) of the pictured balancer

Hello, The rope for our window balance ended up breaking recently. I'm looking to find a replacement for this one. Our window weighs 20 lbs and is a non-tilt. The width of the balance is 1/2 inch with a length of 27 inches. Both the top and bottom fittings have wings that measure to 15/16 inch. The ... (cont.)

Channel Length = 27 inches. There is no stamp. These windows are in a Fleetwood triple-wide modular home. All of these are sliders that are the same size. At this point I'll need 6 balancers for three windows. I don't know if these are/were custom windows made for Fleetwood or not. Each window is a ... (cont.)

Hi, I am the wholesaler who called earlier about pricing on 36x 2640 balances. You suggested I send some photos of what we are replacing. Of the 36, 8 are marked 2640A. But they look identical to the 2640. The 2640A came off a narrower window. All are 27" channels. Thank you.

The string in my Milgard window broke. From my online research the replacement would be a balancer replacement, block and tackle style. On the metal is stamped this information: 26 4 ew cmc 10. We open the window frequently during the summer months so I suspect I should replace both of the balancers ... (cont.)

Metal channel is 1/2" wide and 27" long. Has markings on it that say 26 4 EW CMC 10

I need balancers for both sides of this Milgard Classic single hung. 26 4 AW CMC 7