Viewing all customer Discussions for:

S380-27 27" Series 380 Channel Balance

27 " long. 1/2 " wide stamped on unit 26 space L. unable to read number below stamp of L.

Milgard window, 27 inch balance. The balance says "26 4 AW CMC 2"

the Balance metal only is 27" long

Is this a 26" series 380. Want to get the right ones. I need 8

I need to order one of these please!

Need some of the window balances 27"s

Stamp 26 4 IV CMC 7 Need 4

I need replacements for these. The stamp says 26 3 CJ. When I measured just the metal it it almost 27 inches.

I need the window balance the numbers on my old one say 26 4 BSI PD

There are no identifying stamp marks on the balance. The metal section is 27" long x 1/2" i'm hoping to get a quote for 6 replacements units.

The sash/string is broken on my non tilt Milgard window. The lenght of the channel balance is 27 inches.

Length = 27" Width = 1/2"

Fiberglass mobile home window... installed in a Cavco mobile home. Metal end to metal end measures 27". identified as 26.4 B.S.I. RK

1/2 Channel Balance stamped with 26 4. Im assuming that is the length and width. Several of the ID pictures online look similiar. Its hard to tell which ones I have.Can you also provide the part number of the plastic pieces found attached to the window based on what channel balance I have? or do you ... (cont.)

It says 2620 bs1. It's 1/2 inch wide

Hello, I have a few window channel balances needing replacement, they are marked as “26 4 BX CMC 11” and when searching for that I see 26” versions, but the metal part of the balance measures at 27”, so I’m not sure which one I should be getting. It appears to possibly ... (cont.)

Hello - I am looking to recommendations to replace these on 2 windows in my house. The small window one is marked 26 4 DN Caldwell. The Metal part is 27 inches long. The larger window is marked 32 9 BN Caldwell. The Medal part is 33 inches long. I appreciate the advice.

Hello, I am in need of assistance to determine which window balance is needed. I tried to take photos of the balance at a similar angle to what is on your website.

the channel is half an inchit is 27 inches long not including fittings 26-4 fa2 cmc 13 is written on the unit

Looking for non tilting channel balance. The only number I can see on it is 2630 the metal channel is 27" long and looks to be 5/8" wide