Viewing all customer Discussions for:

S380-33 33" Series 380 Channel Balance

I need to identify this spiting. I need 6 of these. Windows are roughly 25 years old. Also note that the window weigh about 22 lbs each.

I need to find replacement ballast for one window. The old ones have the following info on them "32 4 HL Caldwell". Do you offer a replacement for these and what is the availability? Thanks, Dale

Hello. I need help identifying this balancer and ordering replacements. I ordered 33" series 810 with Option 32C, but they are smaller than this. Please help! -Scott

As you can see in the photo, my apartment's window sashes gave out I slammed down too hard one time, a handyman did an off the cuff repair which also failed over time. Would like to get the right sashes and have them put in, I think the window is otherwise in fine shape. 3240 BSI VB, measured about ... (cont.)

Metal part (excluding plastic) is 30" x 5/8". 29 9 HW CMC 7 is printed on part. Sash weighs 29 pounds.

Which replacement Chanel would you recommend

length of balance 33"

The channel is 5/8×32 Thank You Martin

Hi,I was not able to identify the difference between Series 380 and 385 to replace my 33 inches channel balance. Can you help me considering the photos attached?Thank youCarlos

32 5 AV CMC 2 33" inch channel with the above markings I need to replace them. Thank you for your help!

I need 4 balances for 2 windows of the same size. steel part is 9/16 wide, 5/8 deep. Windows weigh just under 25lbs. I need complete balance part with plastic ends, strings and clips. The part stamped is 3290ca36.Thanks for your HelpMark

Dear Sir / Madam,I require 4 Replacement Counterbalances. I have attached photos.The Number Stamped on the side is: 32 5 GV CMC 2The Lower shoe appears to have a wing etc and therefore I am assuming that I would require 32" (length of steel) and that the replacement model number would be a 3 ... (cont.)

This window is hard to raise and lower. It looks like a piece of the fitting from the bottom fitting is missing. I would like to get a new set of balances. The window would be 20 years old, not sure of brand and don't see anything on the window

trying to match the channel window balance 33" 32-5 AA CMC 7

I need to replace two balancers for a single hung Milgard window. Balancer is stamped with 32 3 IT CMC 0 although the metal piece is 33" in length. I'm unable to find an exact match to these numbers. Our home was built in the 2001/2002 timeframe. FYI, the forth photo shows one balancer installed, ( ... (cont.)

Two have 3240 stamped on them (33" long), and two others have 2640 stamped on them (27" long)They are all 1/2" wide.I need to order 6 of each.

Single hung Milgard vinyl window - 35"x71" Marks on existing hardware - 32 4 F0 Caldwell

I need replacement for Single hung window balance. The balance is stamped as "32 6 JP CALDWELL". I have attached the photos. I need two of these. Please help me identify part number. Thanks.

32 4 HQ Caldwell. 1/2 inch wide

Hi I have a Caldwell channel balance which is 33" long. It has a stamping of 32 5 FQ. What should I order?