Viewing all customer Discussions for:

S380-33 33" Series 380 Channel Balance

Looking for replacement channel balances for our non-tilt vertical sliding windows. The length of the metal is 33". The number stamped on the balance is 3230.

Would like to replace a broken channel balance. Builder used Alpine window. Window # 152-502153 Channel balance # 32-2 BH5 CMC 75 I don't know what would be the SWISCO number.

Hi there, These are stamped as 32 3 DR CALDWELL. Any suggested product(s)? Thanks

The Caldwell channel balance is 33" long (metal only). I would like to order two replacements.

What part should I buy? I need to buy replacement channels for my vinyl windows. They are single hung, non-tilt windows. Each sash weighs 21 pounds. The guide have wings. The bottom winged guide measures 1 inch. The length of the channel aluminum part only measures 33 inches and the width measure ... (cont.)

Hi, I'm looking for 32-3-GP Calwell balance replacement. Could you please suggest replacement parts?

Hi, I need a replacement channel balance. Photos attached of the 'partner' side. It is 33 inches and I believe the stamp is 3250. Just not sure which series. Thank you, -doug

Window balancer

I am in need of 4 of these balancers

Need (6) balancers. 33" for vertical sliding windows. I have attached photos

Hello, thanks for offering this service. I am replacing a broken part and need help identifying the correct replacement. The channel width is 9/16" so I know that is the 1/2" model. The length is 33", metal channel only, plus the two ends. It is hard from me to determine which part number I need. A ... (cont.)

Hi, counter balance is 1/2" wide. Any idea which swisco # would be a suitable replacement? Thank you, Jon

33# window 33 inch metal part long with wings 22/32 and 1/2 inch wide ribbed current balances dont hold window open

I have Caldwell FO 32-4 balances. I need to know what balances I can order that will match the ones I have.

I received the parts today and I installed two of them. They fit just fine, but the springs seem to be weak and do not hold up the window. I'd need to return them back to Swisco and order the correct/better part. So what would you suggest? The info stamped on the old balance: 32-5 JD5 CMC 54 Than ... (cont.)

This balancer is off a Millard single hung vinyl window.

I just want to confirm that I have correctly Identifies the correct Balance. The number on the balance is 3230 and I measured from one end of the balance to the other as 33". The balance is 1/2" wide and 5/8" deep

Which of your products match. Need 2

My channel balance is marked 32 4 av cdc 1 : what do I need to order part number and what window top and bottom sash hardware do I need. The channel balance is 33in

One is a sash balance; the metal part is 33" The other is a connection between two shelves (just trying my luck if you have it)