Viewing all customer Discussions for:

18-166 5/8" Top Sash Guide, Kinco

I need 30 sash guides to go with my recent purchase Of S380-30 guides.Please identify the part I need from the pictures attached thank you very much

Do you have a replacement part like this? Thank you

Hello, Looking to ID this top sash guild. The width at the bottom is 5/8. I took pictures with measuring tape for other dimensions. Thank You -Devyn

I need several channel balances for repair of window. Current channel balance is stamped 2430D with a BS near it, 25 inches long without attachments, 1/2 inch wide, bottom shoe depth is 1 inch, no wings on top or bottom shoes.. From your site, I think it is like your 351. Is this correct? I also n ... (cont.)

The window I need parts for is an aluminum AAMA certification program series mark 40/50 STD.

I would appreciate your opinion prior to order these, will need 30 units. The metal is 27" long and the bottom shoe is 1" so it appears that the S351 with 2640 is the correct replacement. The stamp on the metal is 2640 with a special character after the number. The 18-09 appears to be the best fit o ... (cont.)

Part engages balancer on Jordan aluminum single hung window

Looking for PGT SH-4000 channel slides and sash guides. Please let me know if additional info is needed to determine the correct replacement parts. Thank you.

Looking for the correct top sash balance cap based on the photos provided. No identifiable brand is on the windows.

Please help me choose the correct Sash Top for my Milgard window. Series 3210 - single hung - P.L.# 032-157 I've determined the Series 380 - 3250 is the correct channel balance.

Hi Can you help id this top sash guide? I will also need balances (BSI 2640)and sweep locks for 5 aluminum single sash windows. But a am pending on find this part... Thanks

Top is 1/2 inch X 7/8 Length is 11/2 inch With 5/8

The plastic part on some of the windows is cracked and needs to be replaced

These plastic shoes are attached to the window itself. 5/8" wide by 1 1/2" long. The top flat portion that catches the channel balance is broken off.

I need this part that rests on the spring assembly in the window frame. Also the other side looks like it has a broken part but I don't know what either of them are. Thanks!

I need to replace several channel balances. Please provide part numbers, part and shipping pricing and availability. These are 30" single hung non-swinging windows stamped with "29 4" and "29 9". I also need balance retainer clips. I have additional photos, if required, beyond your site limit of fiv ... (cont.)

Wile replacing broken channel balances the left top Sash Guide broke. Would like confirmation that your PN# 18-188 will fit. Photos are the same part from other side. Window is Milgard circa 1999. The only dimension that looks a bit off is the sideview where your drawing calls out 9/32". Mine appe ... (cont.)

I need 8 of these for 4 of my windows. They all have this same stamp shown in photo. 26 4 EW CMC 10 Thanks

Channel Balance K24S28 need qty 2Nuair Single Hung Windows installed in 1995.Channel Balance imprinted number on aluminum balance is # K24S28.Thank you in advance.Celia

I am looking for the part to replace the window balance. The following dimensions are approximate. The window channel is 30 inches long, 1/2 wide and 5/8 deep. It has a cable and spring system in the back of the channel. The marking on the balance says 30 with another number that I cannot read. ... (cont.)