Viewing all customer Discussions for:

18-166 5/8" Top Sash Guide, Kinco

I can send more photos if needed.

Need to identify window stop and plastic stablizer

I'm looking for this part

How to replace this...and will bottom sash come up with balance all the way to the top of window

Hello My window sash measures 1.5" tall, 5/8" (a bit over that) wide with the very top part being 0.75" wide and 9/16" deep. What is a suitable replacement? Thanks Norman

NEED HELP WHICH PART #

I am repairing an aluminum window in my home I need the part shown in the picture but I have no idea what it is called. The part screws to the top side of the window. I am guessing the channel balance catches on it.

Need the plastic part number that is atttached the window and is supported on the 2340 fixed window balances

I don't know which sash guide is a good match? I also need a couple balance springs too. They are 30 ". From metal end to metal end. The plastic ends are not included in the length.

The house was built in 1998. I have checked and cannot find any markings except "CALDWELL". I also need the plastic piece the fits on top of the movable window and sits in the window channel. and is attached with a screw Any assistance will be wonderful. Thank you in advancePaul

Please identify the correct upper sash guide for my windows in order for me to purchase replacement parts. I have been ordering the S351-29: 29" Series 351 Channel Balances for the same windows. Thank you- Bob

This window would not stay open. Some clip on the top seems broken and the medal rod looks messed up as well. The issues are on the right side (from outside) left (from inside). Not sure what to order to fix.

Sash disengage from the balancer and the window leans to the sides most of the time and the window shakes inside the frame. The balancers are in good condition although they make noises (maybe needs lubricant). I noticed a little chip on the top sash guide. Which one should I replace? ... (cont.)

30 inch length. 1/2inch wide,5/8 deep. stamped 29-2 AU CMC 2 . need sash guides and take out clips also. I would like to submit an order as soon as possible.

Balance is stamped BSI 2730V. The bottom guide is 1 3/32 deep so think it's the 15-004 but can't find a match for the top guide. It has no side tabs is Need help identifying the proper top guide. It has no side tabs and is 1 1/2 inches tall and fits into a 1/2 inch channel. It looks like the 19- ... (cont.)

Looking for this part for non tilt window

The plastic "balance stop" at the top of my window broke...Is there a replacement part available?

Third photo, be616 is of unbroken part in another window. The number 2810P is stamped on the spring housing.

Need help identifying the stops/endcaps. Will need 6 sets. Thank you.

Lawson SH-7500 series window We had previously ordered your part 18-192 but this was not the correct part. Length 1.5" Top piece is 13/16" long By 1/2" wide