Viewing all customer Discussions for:

82-239 Multi-Point Mortise Lock and Keeper, 9-7/8"

Looking for replacement parts for this type of guardian door: Guardian Corsicana Tex 15 CFR 1201 II ANSI Z97 1-2015 SGCC 1248 1/8UA 3.0 MM CAN/CGSB-12.1 M90 Thanks!!!

I need a handle and latch for patio door that has a double martise lock

Hi, I am trying to install asliding glass door handle with a lock. The cutout portion on the door has an opening that is about 7" long is there some sort of plate I can use so that a regular mortise lock will fit? Please recommned what I need. The handle holes are 3/15/16 on center and the door is 1 ... (cont.)

I need to replace the dual locking latch mechanism on an Alumco Aluminite model number is 10034

Hi. I'm trying to find a strike plate for this door. Please lmk if you can help. It's a Simonton. Thanks!

This is a latch and handle from a sliding door.SD-R50-1816-2426-72x96Danny

Patio lock replacement

I dropped my mortise lock into the door. Then I took the door sash off and turned it upside down. But I missed the mortise lock on the way by, and now it's stuck in the top of the door. Please see measurements in attachment. Plus a Swisco guy asked me to measure the hole space on the screw holes o ... (cont.)

Hi I'm looking for the lock mechanism john

Reliabilt Patio Door locking mechanism replacement for model 332 patio door

Hello. Our sliding glass door wouldn't open. We had an expert in glass doors come out. It seemed he ordered the wrong parts and it wasn't worth the trip to come out a third time, so he said he couldn't finish the job. Do you happen to sell the parts we need? Your help is greatly needed and appreci ... (cont.)

Morning: We are looking for a Gliding Patio Door Thumb Latch similar to the attached pictures. Please send me an email if you have this item. Thank you in advance.

I have this latch that keeps getting stuck in locked position. We continue lifting up and jiggling until it u clicked and let's go. Want to replace it but don't know what part to purchase. Please advise.

Looking to purchase locking latch for a Home Depot exterior glass sliding door. The only markings on the latch housing is "Pat Pend" and it is 10" long and a little over an inch wide. I have attached the following: 1-Sticker inside top of door 2-Locking mechanism

The plastic interior piece has broken off the lock and unable to release the lock and open the door. Is there a way to get the handle off without damaging the handle? I's appreciate your response ASAP as I cannot access my deck at this time.

Hello,We need a replacement door handle for a Simonton sliding glass door purchased in 2005. The exterior handle, bottom female threshold is broken off. There is a double locking system with 2 hooks. The hardware inside the door jam is 9" long and the hole spacing is 3 15/16. I believe we can use th ... (cont.)

I am trying to identify the proper multi-point mortise lock for my sliding glass door. I have identified my keeper as your part number 82-249. And, based on the dimensions shown on your website, it looks like both 82-259 and 82-239 will match up to mine. What is the difference between those two l ... (cont.)

The measurements are 9 3/4 and want to know if we need a special handle to go with the latch

Need this lock

Hello Swisco, I am looking for the lock and handle mechanism for a sliding patio door. Sash Controls Canton SD 2265 is on the inside of the handle. I am unable to remove the lock from the door without enlarging the mortise reveal for the lock. The Lock mechanism has two latches. The lock mechanism i ... (cont.)