Viewing all customer Discussions for:

15-192 CertainTeed Pivot Shoe

I am looking for a constant force pivot shoe for bottom window. I have simonton windows. I hope the pictures are helpful. I am not sure the replacement numbers for this part. If you need more information let me know, thanks for your help. My name is Nick.

I believe the spring balance broke off of this piece

The plastic end where the shoe sit has broke. I meed both parts but not sure what to order. Theres no part ID on the part.

I need two replacement shoes for Simonton double-hung windows that are roughly 25 years old. The channel width is 1 3/4", depth 13/16", and channel slot width 1/2". The old shoe is approximately 1 1/2" high.

My windows had been installed in 2005, photo of the label attached. Do you have a fitting part? See pictures. With Sears I had no luck. Thank you for your help Frank

Hello I have 1 CertainTeed window with 2 broken coil springs. These windows were installed in 2003, there is a photo of the factory information in this group. The window with the broken coils is the top sash as you may be able to see from the photos. If you require more pictures I will send them a ... (cont.)

HelloI need parts for my Simonton final windows.For double hung window I need 2 sets (left and right) coil box and pivot shoe.Both upper and lower window pivot shoe on both sides has broken. The coil box and coil are ok but I think I have to replace both.Do you have these parts?N Kobie ... (cont.)

Pivot shoe looks like it's rather big - like 1 inch in diameter or so. Will bar code help identify the size ?

Please see photos. I need pivot shoe holder - it's rather big (almost 1 in in diameter) and a thing that holds spiral in place in the middle of the window

Please advise what part this is and should I replace e in pairs. Need price also please and how to order

These are from Simonton windows. Everything seems to be fine except the shoes have worn down and separated. I see a few possible replacements that may work, but would like your recommendation.

I'm needing some replacement parts for some simonton windows in a house I'm remodeling. Need balancer, pivot shoes, pivot bar and tilt latch. Thanks, Matt

We are trying to identify the proper springs for replacement in Certainteed tilt windows circa 2000. The sash weight is approximately 20 lbs and the original springs have the number 10 stamped on them. Please get back to us with any information you have. Thank you,Jim

The lower "clip" is broken and 1 guide pin is broken on a sears window. Can you see if you can help me out? Thanks, patrick The guid clip pictured is not broken but bent. And the window is impact resistant.

Measurements for the piece are:1 1/4 inch across the top4 1/8 inch in height7/8 inch thicknessI need to order two (2) of these for 2 windows.

Hello, I have Simonton windows, installed about 2010 and on one of the windows I noticed that the Pivot Lock Shoe on the right (looking at the window) side, lower sash appeared to break in two in the middle below the metal locking nut. One part of the plastic frame appears to still be connected to ... (cont.)

I have attached pictures of part and stickers that were still on hand

Aloha. I'm trying to find this part for our sliding windows. Have not been successful in replacing them yetThe window do not have any ID on them. However a repair person recommended you. Would you have these parts. The spring and housing?Let me know if you need more info.Thank youStan ... (cont.)

I am looking for the U shaped plastic piece that houses the sash pivot.

Both coils broke, I need 2 replacement coils, Thank YouPlease call me with any questions John