Viewing all customer Discussions for:

S385-25 25" Series 385 Channel Balance

I am trying to find replacement springs for a Millgard Window. I have more photos if needed. I have no photos of the spring in original position as it was broke and out of place when I first got to job site. I am in Utah and window is in Washington State. Trying to fix window for my 96 yr old aunt. ... (cont.)

Window balancer for Milgrad window vinyl stamped 24 9 IT CMC 2

25 inch

Could you please help me identify the correct 25" channel guide? Thank you!

I need two of 1/2" wide non- tilt window channel banlances, 24.9" long

Hello, replacing my window balances and not sure which ones mine are.Non tilt, 1"2" wide valances. I need ones that are 25" tall and that are 30" tall (measured end of metal to end of metal).One has a marking of: "24-9 IA2 CMC 6" on it.Also going to need replacement top dash guides, but I believe ... (cont.)

good morning- I am looking for 4 replacement springs to match these. Do you charge shipping?

Size: 1/2 " X 25" I found 2440 BSI DA on one side of the channel balance.

Alpine window spec HS-R25 series 280 Rein MST 10050

From jeldwen window

There's a stamp that says 24 2 JJ CALDWELL. The length of the metal channel is 25"

Hello, My windows failure to open. I want to replace the window channel balance. The window is Non-Tilt window. The width is 1/2. Could you help to identify the parts? Thank You!

The steel channel is 25 inches long and five days of an inch deep. One side of the window failed when the rivet holding the spring bent and pulled itself out of the holes which held it. Of course I'm going to be replacing both sides of the window. As best I can tell my son and I installed Windows 2 ... (cont.)

1. Replacing the Channel Balance, and I believe I need S385-25. Existing Channel Balance parts are 1/2" x 25", and the bottom piece measures 1 3/32" deep. Could you please confirm or suggest an alternative? 2. The last picture showing my sash guide measures exactly as part 18-009. My question is, i ... (cont.)

Would like to find replacement part. Glass is about 45w x 23h.thanks,Rick

I need to replace two of these springs fro the window. I only can see a 244 engraving on this one. I have replaced multiple other ones. Can you please help me figure out which 2 to order. I need an easy tension to open

There is a # 2440ff stamped on the part that needs to be replaced. There are 25inches by 1/2 inch wide

Can you identify this for me?

Can you advise what Swissco balance model is the best replacement for what I have now. The one in the pictures is 1/2" width and the metal frame is 25" long. The length of the spring where it attaches to the pins at each end is 15-1/4". The window is non-tilting.

Hi, I have original windows 31 years old. They are none tilt, single hang. I was able to remove this pair of channel balance from one window. But some other windows I can see the one or both channels on the side up to the top. In that case, I couldn't lift the window to the top and then remove it. I ... (cont.)