Viewing all customer Discussions for:

S385-30 30" Series 385 Channel Balance

The number 2940 is stamped on each they are 9/16" by 30".Thanks,Kevin

30.75" in length from plastic tip to tip. Aluminum piece is 30" in length x 1/2" wide. Spring is 18". 9230 is stamped on the aluminum. Also need the two plastic end pieces shown in attached picture.

Need to order and would like to confirm which channel balance to order so I have correct channel balance. Thank you

#'s on 30"- (29-4 KX CMC 7). #'s on 27"-(26-5 LX CMC 11)Thanks for helping find the correct part. A few look a like in your pics. -Michael

The balance springs are stamped with the number 2920. I also need the plastic end pieces as shown in the picture.

One window balance is stamped 34 30 W. The other window balance is stamped with 29 3 FH Do you need pictures to tell me what replacements I need?

The channel is 30" in length. There is a stamp reading (29 4 JP Caldwell) on the channel. I've attached pics of the ends as well.

This channel comes from a PGT window. I will need four pieces total for two windows. The marking states 2960. BS1FP. Rivets snapped and the plastic/nylon pretty old and brittle. Hose built in 2001.

Not sure which one I need. Bottom is 15/16 by 1 3/32. The metal is 30" long.

this is stamped 29DS 48L. I need 6 of these. Thank you

I need your assistance identifying a window part(s). Let me know if you need additional photos.

Measurements are 1/2 inch wide by 30 inches long

I have a broken window balancer with the number 2950 stamped on it. Looking for a replacemen.

need help identifying the ends for a window balance width is 1/2" Numbers printed on old part: 29 4 LV CMC 2 The actual length of the aluminum channel is 30" The measurement between the 2 plastic ends is 29" window weight 26 lbs non-tilt window, single hung window

Windows are side tilt, aluminum frame. Channel is 1/2" x 30" measured. Only markings are 3050. Which slide assembly is needed? It appears that the 30" Series 351 is a 2950, while the 31" Series 351 has a 3050. But my channel is 30" long. Which assembly number is applicable?

Hello, I would like your help in replacing a window balance for a 15 lb window sash. I have included some images for you to review. I could not figure out the correct replacement parts for my window. Thank you for your help, Brian

Attached are photos of the channels removed. 30? long, look just like 380s, except the top is flat. Came on Kinco window, weigh 30.5 lbs. Please devise.

Hi - I want to make sure I get the correct channel blades. The part # on my blade is 29-4 BA CMC 11. It measures approx 30 inches.

My balance channel is 24" long, 1/2 " depth. The stamp read 23-2 DA2 CMC 4. What do I need to replace a new one?

I am noticing that I need new window sash channel balance but also I noticed that the piece on the actual window that hold the balances are also broken. I?m not sure what the name is. Also I measured the length using a tape measure when using that I cane up with 30in but the number on the sash bal ... (cont.)