Viewing all customer Discussions for:

S385-30 30" Series 385 Channel Balance

My window balance has the code 29 9 which I did not see on your chart. Would it be okay to get a 2910 or another number?

The 3 sided piece is 30 inches long.

I have a window that measures 58x32. There are 2 different size balances when I took the bottom sash out. I don't know which one is the correct size? In one of the pictures I measured from the bottom of the window to the top of the bottom sash. I also measured the width of the side jamb to make sur ... (cont.)

Need verification if this in the one I should get? 30" SERIES 385 CHANNEL BALANCE

I would like to know which part to order. Number found: 2940 (see picture) Metal length is aprox. 30"

The balance looks like series 380. 2940We measured 30 inches long, half inch wide.Other numbers on balance are 24. 4 BS1 TE.What do you experts think?Thanks, Kirk

1-marked 2940 bsi vk measures 1/2"wide 31"long and a 1" base plate 1-marked 2840 bsi ax measures 1/2"wide 30" long and a 1" base plate I believe someone replaced the balance with the wrong size (2840) The window measures 51" x 61" inside the house

All the windows in my house are broken and do not stay up. The window sash rods appear to be intact. But it looks like these plastic clips that screw on to the windows are broken on both sides. I need help identifying the top sash guide. Also do you know if the bottom of the window need sash guid ... (cont.)

I need to replace 4 Lawson window balancers stamped 29DS 38

I need to replace these sash rods (I think that's what they are called) I know they are 30" long, but I don't know which model the top and bottom shoes are. I need to replace them on both sides of the window so it may not matter? Please help! Thanks! Craig

I need help identifying the Series for my 2930 Channel Balance for a Non-Tilt Lawson Window. Photos attached. Thanks

294 with wings - looking for part numberLooking for part number of my balancer

My windows are very hard to open. I managed to get the window out. I would like to know if you have an assembled channel balance's for replacement. These are side by side windows so I require (4).Thank YouJohn

need ten tubes they are 30 inches long , can you identify from pictures Thanks Ron

Channel balance for Lawson metal windows.

The 30 in metal bracket has a stamp on the back " 29 9 CX CMC 7"

Stamped....29 2 GU. CMC. 2 Size....1/2 x 30

Hi there, I need help figuring out what type of balance i need to replace this broken one with. There's a number marked on the side: 29 9 AW CMC 7. It's a non tilt window. The length of the metal channel portion is 30". The spring is 18" on the inside of the metal channel. Please advice. Thanks, ... (cont.)

I need to replace a balancer for a Milgard window (Installed in 2002). The part is marked 29 4 DV CMC 7 (see attached photo). I have also attached pictures of the two ends of the balancer and the length of it. The metal groove is 0.5 in and the length of the metal part is almost 30 inches. Not su ... (cont.)

Can you help to ID a replacement part for the attached. 29 9 0A BSI