Viewing all customer Discussions for:

S385-37 37" Series 385 Channel Balance

Hello I've found out some end guide numbers on another site for my caldwell block and tackle balance, and i was trying to cross compare / validate with your part numbers but can't make a match. i BELIEVE i have 15P142 top guide, and 15P122 bottom guide. Do you have a compatible guide? ... (cont.)

I need the part number as I need to place an order for my sliding up down window. This is for 37" window balance channel. It will be appreciated for your quick response. Thank you Rupak

Can you assist in determining which channel balance I should purchase for Rollyson Windows? This is the information on the balance 36 4 DO Caldwell. Thank you

I have two windows with balancers that need to be replaced. Both balancers are 33 inches long and I included serial numbers in the photos. The balancers I removed look similar other than the spring is larger in the balancer from the larger window.

Photos show length of 37", back is 1/2", side is 5/8" approximately!Stamped on channel is number "3650". Note end pieces similar to your Series 350, 380, and 385. If tighter measure needed let me know. I have your install guide from your web site. Additional instructions might be helpful.I want t ... (cont.)

Window decal says hlc 3554 by 96 also h lc50 52 x 76 the balance is 37 in metal to metal

Markings on part say 36 3 IQ Caldwell

Looking for window sash balance.

36 3. F9. Caldwell That's the number stamp ed on the balance The balance is actually 37" long The balance is 6/8ths wide Top plastic piece is 1 1/2" long and 6/8ths wide with the wings 7/8 this wide Bottom wings are 7/8ths wide and 1 1/2" long. Can't find a number that matches any thing online? C ... (cont.)

Old ones broken! No markings or stamps. 37" long, 1/2" (actually 9/16 like you say).

Can you assist with my selection. The stamp on the Channel balance is as follows; 36DS45 The Sash weight is 38.5 lbs The balance length is 37 inches with winged ends on both ends

37"Long, 9/16"W and 5/8" deep, channel balance spring for a 9.2 pound window. The current balance has the number 3610B (the B is upside down) stamped on the metal channel. I can't tell for sure which end parts I need from your pictures. Can you advise? Thank you.

Single hung non tilt window.

D-36-4 are most sizes of my windows. 36-3-d is one window in pics. Springs broken. What size should i get? Will this make my windows leak being broken? I usually dont open them. But when i wash them some leak.? Thank you!

Can you help me identify these channel balances? They look to be ~37" long.

Length as measured from wing to wing is 37 inches. Balance spring for window. Please see previous communication. What part no. do I need.

I have 4 windows with this type of springs, only one spring is broke. I believe as long as I'm replacing the broken one I should replace them all.

Norandex window has channel balances on both sides. Number stamped on channel is 3650.

I need to know how much the cost with delivery i live in fortmyers

PGT balance spring 37" long 9/16" deep 1/2" wide hemmed channel 36 5 GS Caldwell imprinted on it. Need approx 12. Please advise lead time Thanks